So we're trying to replace Nick's crank angle sensor, but we're just wanting to confirm a couple bits.
One being that from looking at our spare engine, we must remove this pully, is that correct?
![Image](http://technikhaus.co.nz/fto/2014-01-14%2013.23.41.jpg)
Which from some searching should lead us to this, with the sensor in place behind (not my pic):
![Image](http://i894.photobucket.com/albums/ac143/perrinr1_photo/IMG_0022.jpg)
Now, I'm assuming that to in doing all this we will have to remove the accessory belts?
Any help appreciated.
Thanks,
Braydon.