Wrecking whole car

Post by **Bennoz** » Tue Nov 15, 2011 8:59 pm

Ok guys & gals, time to pop the rest of this wreck up for sale

I've got some 'featured items' pictured here, the rest - just flick me a pm

Light up kick plates $150. Usualy wear & tear for their age. Comes with all wiring & plugs.

*Mint Condition* Mivec engine cover. Make me an offer.

Crossmember with 2 x perfectly good solid lower engine mounts $60

DC lip compliments of Subby. Needs a little bit of fibre glass repair underneath (bottom out wear thin) but otherwise ok, make an offer.
(Proceeds to be used at Syd FTO xmas party tab)

Faux woodgrain tip cover!

Make an offer (beer would be acceptable)

Stock air box. Make an offer.

Gen Mitsi oil temp gauge. $40

Climate control unit with surround (vents etc) $60

SCA brand (aka Super Cheap Auto) generic gear nob $15

Driver side tailight, pretty much mint condition $100

Passenger tail light, has 6-7cm crack through centre of it (still water tight) $50

Rear wiper assembly. Can come with loom, rear windscreen & rear parcel tray to suit if need be. Make an offer.

Indicator assembly. Rear wiper version $75.

Reconditioned headlights. No cracks, no internal fractures or anything. $125 per side, $220 for the pair.

Anything else you can think of, the car probably still has it in it. Full interior with seats etc, engine, suspension, the works...

Shane001 · Post by **Shane001** » Tue Nov 15, 2011 9:20 pm

How the f**k does a car with a 180K km engine have a mint condition Mivec cover on it?

U sure that's the original engine? Have you checked the engine number against the VIN plate?

Post by **Bennoz** » Tue Nov 15, 2011 9:21 pm

Shane001 wrote:How the f**k does a car with a 180K km engine have a mint condition Mivec cover on it?

you sure that's the original engine? Have you checked the engine number against the VIN plate?

You know how its possible? By not f**king around & trying to modify the c**t of thing!!!

All this car got was serviced!!!

Forgot to mention other bits!!

GPX alternator $150

AC compressor $100

PS Pump $75

Radiator with fans $125 (manual version)

Post by **aza013** » Tue Nov 15, 2011 9:27 pm

I'm thinking about the Mivec engine cover.
If it's still around in a week I will put a bid on it

.

bass_twitch · Post by **bass_twitch** » Tue Nov 15, 2011 9:54 pm

What condition are the front seats in and how much each? (My drivers side is falling apart..)

Astron_Boy · Post by **Astron_Boy** » Tue Nov 15, 2011 10:02 pm

I wouldn't mind the oil temp guage actually if the sensor is included (or is it ecu tapped already?)

Meanwhile, c*** of a thing getting the centre piece off to install it

Edit: also might just add to your post Bennoz for a slight correction, those mounts were for manual, as we discussed. Otherwise you wouldn't still have it

Post by **Vectose** » Tue Nov 15, 2011 11:03 pm

Also interested in the oil temp gauge.

phi-tec · Post by **phi-tec** » Wed Nov 16, 2011 1:37 am

hey bennoz whats the condition of the alternator? i need a new one, how much would postage be to brisbane? need to consider my options

Post by **Bennoz** » Wed Nov 16, 2011 7:41 am

phi-tec wrote:hey bennoz whats the condition of the alternator? i need a new one, how much would postage be to brisbane? need to consider my options

Well, it has done 180,000kms, so it might be worth throwing a new set of bushes in while its out. Having said that, it was working perfectly when I drove it 2 weeks ago.

Postage to Brissy for something around that weight would be about $30 bucks I'd reckon.

Post by **Bennoz** » Wed Nov 16, 2011 7:43 am

bass_twitch wrote:What condition are the front seats in and how much each? (My drivers side is falling apart..)

Passenger is in good nick, drivers has the usual wear on the bolster, no holes, but a bit soggy to touch. Welcome to come have a look.

Astron_Boy wrote:I wouldn't mind the oil temp guage actually if the sensor is included (or is it ecu tapped already?)

Its the Mitsi sump plug sender with the wire hanging off.

bass_twitch · Post by **bass_twitch** » Wed Nov 16, 2011 7:45 am

Bennoz wrote:
bass_twitch wrote:What condition are the front seats in and how much each? (My drivers side is falling apart..)
Passenger is in good nick, drivers has the usual wear on the bolster, no holes, but a bit soggy to touch. Welcome to come have a look.

Astron_Boy wrote:I wouldn't mind the oil temp guage actually if the sensor is included (or is it ecu tapped already?)
Its the Mitsi sump plug sender with the wire hanging off.

just wondering, would the passenger side fit instead of my drivers side? Is there any difference in them? (or in installation?)

Post by **Bennoz** » Wed Nov 16, 2011 7:46 am

bass_twitch wrote:
Bennoz wrote:
bass_twitch wrote:What condition are the front seats in and how much each? (My drivers side is falling apart..)
Passenger is in good nick, drivers has the usual wear on the bolster, no holes, but a bit soggy to touch. Welcome to come have a look.

Astron_Boy wrote:I wouldn't mind the oil temp guage actually if the sensor is included (or is it ecu tapped already?)
Its the Mitsi sump plug sender with the wire hanging off.
just wondering, would the passenger side fit instead of my drivers side? Is there any difference in them? (or in installation?)

LOL cant be done, tried it.

bass_twitch · Post by **bass_twitch** » Wed Nov 16, 2011 7:47 am

Bennoz wrote:
bass_twitch wrote:
Bennoz wrote:
bass_twitch wrote:What condition are the front seats in and how much each? (My drivers side is falling apart..)
Passenger is in good nick, drivers has the usual wear on the bolster, no holes, but a bit soggy to touch. Welcome to come have a look.

Astron_Boy wrote:I wouldn't mind the oil temp guage actually if the sensor is included (or is it ecu tapped already?)
Its the Mitsi sump plug sender with the wire hanging off.
just wondering, would the passenger side fit instead of my drivers side? Is there any difference in them? (or in installation?)
LOL cant be done, tried it.

dammit! It was worth a shot...

Eltnot · Post by **Eltnot** » Wed Nov 16, 2011 9:55 am

Does it have the controls for electric folding mirrors. My switch to folder them in is a bit stuffed, so wouldn't mind a replacement.

Post by **Bennoz** » Wed Nov 16, 2011 10:17 am

Eltnot wrote:Does it have the controls for electric folding mirrors. My switch to folder them in is a bit stuffed, so wouldn't mind a replacement.

Yup. Hows 10 bucks plus postage?

Astron_Boy · Post by **Astron_Boy** » Wed Nov 16, 2011 10:22 am

Bennoz wrote:Its the Mitsi sump plug sender with the wire hanging off.

Hmmm. So I take it, I'd have to get a bung put in to my sump?

Post by **Bennoz** » Wed Nov 16, 2011 10:37 am

Astron_Boy wrote:
Bennoz wrote:Its the Mitsi sump plug sender with the wire hanging off.
Hmmm. So I take it, I'd have to get a bung put in to my sump?

I hope that not a euphemism...

No, the sump plug is the sender. Wire hanging out of it etc

Shane001 · Post by **Shane001** » Wed Nov 16, 2011 11:41 am

Can you take a pic of the sump plug please

I'll take it if Astron Boy doesn't, would be useful in the racecar

Post by **Vectose** » Wed Nov 16, 2011 11:55 am

Shane001 wrote:Can you take a pic of the sump plug please

I'll take it if Astron Boy doesn't, would be useful in the racecar

I posted right after Astron Boy that I was interested in it.

Shane001 · Post by **Shane001** » Wed Nov 16, 2011 12:06 pm

no worries

FTO AUSTRALIA