Mivec Range

General Questions and comments

Moderators: IMC, Club Staff

G_A_V
Veteran Mechanic
Posts: 1020
jedwabna poszewka promocja
Joined: Sun Aug 04, 2002 5:00 pm
Location: Sydney

Post by G_A_V »

does anyone find their car is very jerky when its cold ?? or when its first started ?? and the exhaust is really loud at around 3.5k ??
I find my car is very hard to drive when cold unless i acclerate, its very jerky, and it will idle as high as 2.5k sometimes for a few secs
G1
Mechanic
Posts: 728
Joined: Sun Aug 04, 2002 5:00 pm
Location: VW Bora V6 4Motion
Contact:

Post by G1 »

well i personally dont have the time to let it idle longer than about 15-30sec in the morning rush - at least give the oil time to circulate

according to ruchi, maybe this was a good thing haha
Disrespect is easy. Respect is the difficult road to take.
User avatar
FTO338
Oldtimer
Posts: 6712
Joined: Sun Feb 09, 2003 6:00 pm
Location: Port Melbourne: Pimping with RX400h, B200 Turbo.

Post by FTO338 »

Hey ruchi, will those theory change if you use oil addictive? I'm aware there are few ppl here use them.
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
ruchi
Oldtimer
Posts: 1845
Joined: Tue Oct 14, 2003 5:00 pm
Location: Melbourne

Post by ruchi »

Short answer:
no

Long answer:
While the oil additives should help by increasing viscosity thereby reducing engine wear, you still want to get your engine up to operating temperature as quickly as posible to create the seal between the piston rings and the chamber walls. Until this seal occurs the air/fuel mixture can contanimate the oil and the pressure of the compression will also be lower.
MIVEC is My Friend :D
User avatar
FTO338
Oldtimer
Posts: 6712
Joined: Sun Feb 09, 2003 6:00 pm
Location: Port Melbourne: Pimping with RX400h, B200 Turbo.

Post by FTO338 »

Thax Bro, now i get extra 15mins of sleep in the morning :D
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
ruchi
Oldtimer
Posts: 1845
Joined: Tue Oct 14, 2003 5:00 pm
Location: Melbourne

Post by ruchi »

lol :lol:
MIVEC is My Friend :D
User avatar
GPXXX
Oldtimer
Posts: 3433
Joined: Sat Apr 12, 2003 5:00 pm
Location: < the matrix >

Post by GPXXX »

G_A_V wrote:does anyone find their car is very jerky when its cold ?? or when its first started ?? and the exhaust is really loud at around 3.5k ??
I find my car is very hard to drive when cold unless i acclerate, its very jerky, and it will idle as high as 2.5k sometimes for a few secs
mine does.. apparently it's the clutch - it bites more when it's cold, but starts to slip a little when warmed up (which s why it's smoother on the pickup). It depends on how brutal you are on the clutch, if you pop it during accel. when the car is cold, then yes it will jerk... Seems to occur on other cars too... :roll:
G_A_V
Veteran Mechanic
Posts: 1020
Joined: Sun Aug 04, 2002 5:00 pm
Location: Sydney

Post by G_A_V »

not only then, but when i have the clutch fully engaged (foot completly off) and i slowly accelerate in first gear it will acclerate quick and then slow down a little if you know what i mean. So usually i justh ave to drive with my foot flat to the floor and change gears quickly (at lowwer revs) otherwise the car speeds up and slows down a lot when i have half throttle when its cold
User avatar
GPXXX
Oldtimer
Posts: 3433
Joined: Sat Apr 12, 2003 5:00 pm
Location: < the matrix >

Post by GPXXX »

hmmm, mine seems to jerk only on the clutch pickup in 2nd... and that's after 3mins warm up and pulling out of the car park :roll:

but no such problem like urs on partial throttle in 1st gear though'...
User avatar
dannyboyau
Veteran Mechanic
Posts: 979
Joined: Sat Sep 28, 2002 5:00 pm
Location: that speck disappearing in the distance

Post by dannyboyau »

oops

i should have explained more clearly

I t has a lot more to do with the differant rates of thermal expansion for the differant engine parts. Plus the viscosity of the oil when cold. for example your piston will heat up much quicker than your block and the clearances between the piston and the piston wall will get smaller then they would be once the block reaches operating temperature, during this time if you push it too hard you will get more wear than you would once it gets hot


but basicly dont thrash you engine when it is cold or you will wear it out
User avatar
RichardH
Grease Monkey
Posts: 309
Joined: Sat Aug 10, 2002 5:00 pm
Location: Perth, WA
Contact:

Post by RichardH »

G_A_V wrote:not only then, but when i have the clutch fully engaged (foot completly off) and i slowly accelerate in first gear it will acclerate quick and then slow down a little if you know what i mean. So usually i justh ave to drive with my foot flat to the floor and change gears quickly (at lowwer revs) otherwise the car speeds up and slows down a lot when i have half throttle when its cold
Yeah, mine's always done that. 4 years now, and no hint that there's an issue. :)

I just does it for a few seconds the first time when stone cold on a chilly morning.

- Rich
User avatar
payaya
Oldtimer
Posts: 3670
Joined: Sat Sep 06, 2003 5:00 pm

Post by payaya »

G_A_V wrote:not only then, but when i have the clutch fully engaged (foot completly off) and i slowly accelerate in first gear it will acclerate quick and then slow down a little if you know what i mean. So usually i justh ave to drive with my foot flat to the floor and change gears quickly (at lowwer revs) otherwise the car speeds up and slows down a lot when i have half throttle when its cold
check your idle speed controller.

i know what you mean i have the same problem, power delivery isnt smooth, revs seems to rise and drop.

Also you dont need to warm up a modern engine. Engines of the past yes, its not neccessary these days.

When your engine is warm you got to think your tansmission oil is still cold. It takes around 15-20 mintues for tranny oil to totally heat up.
Post Reply