where do u guys get fto on dyno?
Moderators: IMC, Club Staff
-
- Grease Monkey
- Posts: 105
- jedwabna poszewka promocja
- Joined: Sun Nov 12, 2006 6:00 pm
- Location: sydney
where do u guys get fto on dyno?
Hey guys , i just wanna get a dyno sheet for my fto before i put some mods on,,can anyone tell me where is the better place to go?how much it would cost me ? i am in Marsfield ,Sydney area, any suggestions?
who has the most power NA fto here ? what's the figure?
thank u guys..
who has the most power NA fto here ? what's the figure?
thank u guys..
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
We had a group Dyno day at Menai a little while back ... Pulse racing I think it was ...
As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...
I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...
As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...
What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...
I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...
As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...
I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...
As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...
What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...
I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
- Delvance
- Veteran Mechanic
- Posts: 1194
- Joined: Wed Nov 15, 2006 6:00 pm
- Location: Sydney South
Most powerful n/a fto dyno i've heard in Aus is 126kw atw. I believe Bennoz's once achieved this ? But now runs at around 120kw atw. Boris's car had 126kw atw too.
You should ask Spetz for a dyno sheet if he's willing to give it out. Safe to say he owns one of the most worked (bolt on wise) fto engines in Aus.
Stock manual should get anywhere from 90-95kw atw.
I got to 115.6kw atw myself but the project was never finished.

You should ask Spetz for a dyno sheet if he's willing to give it out. Safe to say he owns one of the most worked (bolt on wise) fto engines in Aus.
Stock manual should get anywhere from 90-95kw atw.
I got to 115.6kw atw myself but the project was never finished.

- Delvance
- Veteran Mechanic
- Posts: 1194
- Joined: Wed Nov 15, 2006 6:00 pm
- Location: Sydney South
- Bennoz
- National President
- Posts: 23676
- Joined: Fri Jan 21, 2005 6:00 pm
- Location: Sydney
- Contact:
-
- Grease Monkey
- Posts: 105
- Joined: Sun Nov 12, 2006 6:00 pm
- Location: sydney
thanks a lot ,ROCK_IT !! i think MRT is the closet place but they charge $150 for 3 dyno runs...i think its too expensive ...rock_it wrote:We had a group Dyno day at Menai a little while back ... Pulse racing I think it was ...
As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...
I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...
As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...
What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...
I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...
my fto is YELLOW GPX MANUAL 95MODEL , LIMITED EDITION..only done the exhaust and intake system..67000KMS ...excellent condition...i hope my fto can get around 105kws atw..i will post some pics later on..
I will probably go for Richol.. anyone got address?
- robsta
- Veteran Mechanic
- Posts: 897
- Joined: Tue Aug 30, 2005 5:00 pm
- Location: Morayfield, QLD
Nah It didn't come with the RPW pipes, he must of sold them already cause he didnt mention them.Bennoz wrote:Did you get the rpw pipes off him as well? It'd go like the clappers with them onrobsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going nowIts a nice car hehe
Although they will be turning up at my work in a couple of days

- FTO338
- Oldtimer
- Posts: 6712
- Joined: Sun Feb 09, 2003 6:00 pm
- Location: Port Melbourne: Pimping with RX400h, B200 Turbo.
Oh so you the one who got Borris's ride, lucky you, he love his FTO like a baby.robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going nowIts a nice car hehe
Yeah I've got the dyno graph of Boris, Grant and Pete's FTO (all ACT members), from memory Grant got the highest output of the three.
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
-
- Grease Monkey
- Posts: 105
- Joined: Sun Nov 12, 2006 6:00 pm
- Location: sydney
-
- Mechanic
- Posts: 467
- Joined: Mon Aug 02, 2004 5:00 pm
- Location: Melbourne
- Contact:
hey yellowftogpx, got a pic of your car? i'm yellow too!
EZCONSOLE & EZMODCHIPS - We repair, upgrade and buy off Xbox 360, Wii, NDS, PS2 and PS3. Pickup & delivery services available. Xbox, Wii and NDS repair and opening tools available. Reasonable offers for non-working xbox 360 and Wii. Contact me for all oth
-
- Grease Monkey
- Posts: 105
- Joined: Sun Nov 12, 2006 6:00 pm
- Location: sydney
-
- Veteran Mechanic
- Posts: 1046
- Joined: Mon Feb 12, 2007 6:00 pm
- Location: Brisbane
- boarsai
- Mechanic
- Posts: 566
- Joined: Tue Nov 21, 2006 6:00 pm
- Location: Brisbane <-> Sunshine Coast
- Contact:
Better yet, make a gallery on the ... gallery.akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!
http://www.ftoaustralia.com/modules.php?name=gallery2

-
- Grease Monkey
- Posts: 105
- Joined: Sun Nov 12, 2006 6:00 pm
- Location: sydney
THANX MATE !eThix wrote:get photobucket.yellowftogpx wrote:yeh, i want to ..but how ?? have no idea how to post the pics.akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!
[/img]
and if u don't know what that is, google it
HERE IS THE LINK http://s239.photobucket.com/albums/ff68/clydesfto/
they were taken in the garage so they look a little bit dark ..
i will take more pics under the sunshine another day..
- FtoSam
- Oldtimer
- Posts: 3924
- Joined: Wed Jul 13, 2005 5:00 pm
- Location: Brisbane West
- Contact:
I had clutch die at 188hp... at 3,500rpm... and it was rising quickly...
aiming for 300hp when its back in a few weeks... but have been warned it may creep over the 500hp mark with it setup for power...
but its not N/a...
Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...
would be over 160kw though
aiming for 300hp when its back in a few weeks... but have been warned it may creep over the 500hp mark with it setup for power...
but its not N/a...
Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...
would be over 160kw though

If you need good deal on photography, let me know.
-
- Grease Monkey
- Posts: 105
- Joined: Sun Nov 12, 2006 6:00 pm
- Location: sydney
hey sam ,,how much have u spent on your FTO ? how many kws atw your fto got? really want to take a ride in your fto and see how a turbo fto performs..FtoSam wrote:I had clutch die at 188hp... at 3,500rpm... and it was rising quickly...
aiming for 300hp when its back in a few weeks... but have been warned it may creep over the 500hp mark with it setup for power...
but its not N/a...
Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...
would be over 160kw though