where do u guys get fto on dyno?

General Questions and comments

Moderators: IMC, Club Staff

yellowftogpx
Grease Monkey
Posts: 105
jedwabna poszewka promocja
Joined: Sun Nov 12, 2006 6:00 pm
Location: sydney

where do u guys get fto on dyno?

Post by yellowftogpx »

Hey guys , i just wanna get a dyno sheet for my fto before i put some mods on,,can anyone tell me where is the better place to go?how much it would cost me ? i am in Marsfield ,Sydney area, any suggestions?
who has the most power NA fto here ? what's the figure?
thank u guys..
User avatar
rock_it
Oldtimer
Posts: 6599
Joined: Sun Jun 10, 2007 5:00 pm
Location: The Shire .. NSW
Contact:

Post by rock_it »

We had a group Dyno day at Menai a little while back ... Pulse racing I think it was ...

As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...

I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...

As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...

What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...

I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...
User avatar
rock_it
Oldtimer
Posts: 6599
Joined: Sun Jun 10, 2007 5:00 pm
Location: The Shire .. NSW
Contact:

Post by rock_it »

Here you go ...

Image

and thread is here ....

http://www.ftoaustralia.com/modules.php ... &start=100
User avatar
Delvance
Veteran Mechanic
Posts: 1194
Joined: Wed Nov 15, 2006 6:00 pm
Location: Sydney South

Post by Delvance »

Most powerful n/a fto dyno i've heard in Aus is 126kw atw. I believe Bennoz's once achieved this ? But now runs at around 120kw atw. Boris's car had 126kw atw too.

You should ask Spetz for a dyno sheet if he's willing to give it out. Safe to say he owns one of the most worked (bolt on wise) fto engines in Aus.

Stock manual should get anywhere from 90-95kw atw.

I got to 115.6kw atw myself but the project was never finished.

Image
User avatar
Delvance
Veteran Mechanic
Posts: 1194
Joined: Wed Nov 15, 2006 6:00 pm
Location: Sydney South

Post by Delvance »

rock_it wrote: BD4's had a Dyno at Ryde
BD4's is gone...has been for awhile. They also had an old mainline dyno one eww (and it also read high).

Btw, price wise you're looking at between $60-$88 for 3 or 4 runs (depends on the place).
User avatar
robsta
Veteran Mechanic
Posts: 897
Joined: Tue Aug 30, 2005 5:00 pm
Location: Morayfield, QLD

Post by robsta »

Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now :) Its a nice car hehe
User avatar
Bennoz
National President
Posts: 23676
Joined: Fri Jan 21, 2005 6:00 pm
Location: Sydney
Contact:

Post by Bennoz »

robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now :) Its a nice car hehe
Did you get the rpw pipes off him as well? It'd go like the clappers with them on 8)
User avatar
Delvance
Veteran Mechanic
Posts: 1194
Joined: Wed Nov 15, 2006 6:00 pm
Location: Sydney South

Post by Delvance »

robsta,

Definitely a nice car...if i didn't have mine i would've bought that one too. And it eventually went for way under what it should've...nice pick!
yellowftogpx
Grease Monkey
Posts: 105
Joined: Sun Nov 12, 2006 6:00 pm
Location: sydney

Post by yellowftogpx »

rock_it wrote:We had a group Dyno day at Menai a little while back ... Pulse racing I think it was ...

As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...

I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...

As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...

What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...

I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...
thanks a lot ,ROCK_IT !! i think MRT is the closet place but they charge $150 for 3 dyno runs...i think its too expensive ...
my fto is YELLOW GPX MANUAL 95MODEL , LIMITED EDITION..only done the exhaust and intake system..67000KMS ...excellent condition...i hope my fto can get around 105kws atw..i will post some pics later on..
I will probably go for Richol.. anyone got address?
User avatar
Delvance
Veteran Mechanic
Posts: 1194
Joined: Wed Nov 15, 2006 6:00 pm
Location: Sydney South

Post by Delvance »

Lol $150 for 3 runs...hahaha.
User avatar
robsta
Veteran Mechanic
Posts: 897
Joined: Tue Aug 30, 2005 5:00 pm
Location: Morayfield, QLD

Post by robsta »

Bennoz wrote:
robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now :) Its a nice car hehe
Did you get the rpw pipes off him as well? It'd go like the clappers with them on 8)
Nah It didn't come with the RPW pipes, he must of sold them already cause he didnt mention them.
Although they will be turning up at my work in a couple of days :D I ordered some myself haha
User avatar
FTO338
Oldtimer
Posts: 6712
Joined: Sun Feb 09, 2003 6:00 pm
Location: Port Melbourne: Pimping with RX400h, B200 Turbo.

Post by FTO338 »

robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now :) Its a nice car hehe
Oh so you the one who got Borris's ride, lucky you, he love his FTO like a baby.

Yeah I've got the dyno graph of Boris, Grant and Pete's FTO (all ACT members), from memory Grant got the highest output of the three.
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
yellowftogpx
Grease Monkey
Posts: 105
Joined: Sun Nov 12, 2006 6:00 pm
Location: sydney

Post by yellowftogpx »

robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now :) Its a nice car hehe
126KWS atw ?!!! this is awesome... what mods have u done on your fto? can u list them?any pics?what model is it?
akumi
Mechanic
Posts: 467
Joined: Mon Aug 02, 2004 5:00 pm
Location: Melbourne
Contact:

Post by akumi »

hey yellowftogpx, got a pic of your car? i'm yellow too!
EZCONSOLE & EZMODCHIPS - We repair, upgrade and buy off Xbox 360, Wii, NDS, PS2 and PS3. Pickup & delivery services available. Xbox, Wii and NDS repair and opening tools available. Reasonable offers for non-working xbox 360 and Wii. Contact me for all oth
yellowftogpx
Grease Monkey
Posts: 105
Joined: Sun Nov 12, 2006 6:00 pm
Location: sydney

Post by yellowftogpx »

akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!
yeh, i want to ..but how ?? have no idea how to post the pics.
[/img]
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

yellowftogpx wrote:
akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!
yeh, i want to ..but how ?? have no idea how to post the pics.
[/img]
get photobucket.
and if u don't know what that is, google it
User avatar
boarsai
Mechanic
Posts: 566
Joined: Tue Nov 21, 2006 6:00 pm
Location: Brisbane <-> Sunshine Coast
Contact:

Post by boarsai »

akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!
Better yet, make a gallery on the ... gallery.
http://www.ftoaustralia.com/modules.php?name=gallery2

:D
yellowftogpx
Grease Monkey
Posts: 105
Joined: Sun Nov 12, 2006 6:00 pm
Location: sydney

Post by yellowftogpx »

eThix wrote:
yellowftogpx wrote:
akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!
yeh, i want to ..but how ?? have no idea how to post the pics.
[/img]
get photobucket.
and if u don't know what that is, google it
THANX MATE !
HERE IS THE LINK http://s239.photobucket.com/albums/ff68/clydesfto/
they were taken in the garage so they look a little bit dark ..
i will take more pics under the sunshine another day..
User avatar
FtoSam
Oldtimer
Posts: 3924
Joined: Wed Jul 13, 2005 5:00 pm
Location: Brisbane West
Contact:

Post by FtoSam »

I had clutch die at 188hp... at 3,500rpm... and it was rising quickly...


aiming for 300hp when its back in a few weeks... but have been warned it may creep over the 500hp mark with it setup for power...



but its not N/a...


Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...

would be over 160kw though
Image

If you need good deal on photography, let me know.
yellowftogpx
Grease Monkey
Posts: 105
Joined: Sun Nov 12, 2006 6:00 pm
Location: sydney

Post by yellowftogpx »

FtoSam wrote:I had clutch die at 188hp... at 3,500rpm... and it was rising quickly...


aiming for 300hp when its back in a few weeks... but have been warned it may creep over the 500hp mark with it setup for power...



but its not N/a...


Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...

would be over 160kw though
hey sam ,,how much have u spent on your FTO ? how many kws atw your fto got? really want to take a ride in your fto and see how a turbo fto performs..
Post Reply