Page 1 of 1
turboing
Posted: Sat Jul 22, 2006 5:14 pm
by cheshcat
i want to know if anyone can tell me if i can turbo my car with a t28 turbo running at 6psi... will it wreck my engine because of the high compression.. or does anyone know of a way to lower the compression in ftos so they can withstand high boost... please be truthful i dont want to blow my engine..
Posted: Sat Jul 22, 2006 5:16 pm
by kingsparticus
where are u from, if your in brisbane there is one place i have seen a nice killer turbo job done on an fto, its my mates, so pm me and we can get u boosting.....mmmmmmmmboost!!
Posted: Sat Jul 22, 2006 11:25 pm
by akuma3
i think getting engineer cert is your next problem
Posted: Sun Jul 23, 2006 12:01 am
by kingsparticus
nah engineering a turbo isnt to hard, unless the rules have already changed
Posted: Sun Jul 23, 2006 12:21 am
by RedlineGX
6psi is ok once you have the car tuned properly. Is this a mivec and what transmission? You should be fine in any case altho if I had a 4spd. Tip that would be my biggest concern.
I've been running 4psi for the past 6 months and will be stepping to 6/7 in a few weeks when my emanage ultimate gets here. And that's on standard compression. Just make sure its tuned properly, timing retarded etc and put decent gas in and you should be fine. If you want to be v.safe you could get a decompression head gasket from RPW but personally i dont think its necessary until you break the 6psi barrier.
Posted: Sun Jul 23, 2006 12:22 am
by kingsparticus
sounds like u have started very nice project with your mivec turbo
Posted: Sun Jul 23, 2006 1:12 am
by frozenwaffles
redline...do you have any pics etc or details of your project???
Posted: Sun Jul 23, 2006 4:55 am
by RedlineGX
http://www.ftoaustralia.com/modules.php ... pic&t=6734
Here is a more recent photo of the engine bay although I have changed turbo since then...
Posted: Sun Jul 23, 2006 5:08 am
by frozenwaffles
ok more questions on this....
what size turbo did you use?
would a single sided intercooler make the whole project easier?
Posted: Sun Jul 23, 2006 5:17 am
by frozenwaffles
also do you need a external wastegate if the turbo has an internal one???
Posted: Sun Jul 23, 2006 1:21 pm
by RedlineGX
Turbo is a T3 but the GT28 would also be fine. Single Sided intercooler could also work, depending on how you plan on running it but I dont think it would make a big difference. Basically you have to examine your situation and see what fits and work to suit. I currently have an external wastegate but you would not need one if the turbo has an internal one, that would be easier since it would be less piping.
Posted: Sun Jul 23, 2006 6:23 pm
by khunjeng
love the radiator shield...looks hot - make me 1 please!