Urgent! Keep blowing headlight fuse - and+ volt to fuse Help
Posted: Sun Jun 26, 2011 7:15 pm
Hey keep blowing the 40a Fuse for the headlights(number 14 on the 'fuse box translation' in fto help) and when tested 1 side of the fuse is + and 1 is - and reads a whole 12 volts. i have dismantled the fuse box and cut the wire right after the terminal (the 1 thats got - volt running through it is from the headlight half of the circuit.
i think that there must be a relay after the fuse because the fuse is live all the time regardless of if the healights are on or off. the red and white wire that goes from the fusebox to the relay maybe if there is one and then to the headlights runs str8 down in a big loom after it leavs the fusebox.
so where is this relay if there is 1? ive taken all the relays out in the fuse box with a multimeter hooked up (posative constant and negative(which shouldent have anything running through it with the fuse out) and voltage stays the same so its not that.
What else can i do/test?
i think that there must be a relay after the fuse because the fuse is live all the time regardless of if the healights are on or off. the red and white wire that goes from the fusebox to the relay maybe if there is one and then to the headlights runs str8 down in a big loom after it leavs the fusebox.
so where is this relay if there is 1? ive taken all the relays out in the fuse box with a multimeter hooked up (posative constant and negative(which shouldent have anything running through it with the fuse out) and voltage stays the same so its not that.
What else can i do/test?