Breakers in Auz ?

RichardB · Post by **RichardB** » Sun Mar 29, 2009 11:40 pm

Are there any good FTO breakers in OZ that I may be able to get a manual box from?

nvr2low · Post by **nvr2low** » Sun Mar 29, 2009 11:53 pm

hey mate manual boxs are very rare to find in australia mate. You might need to source one from japan buddy.

RichardB · Post by **RichardB** » Mon Mar 30, 2009 1:50 am

nvr2low wrote:hey mate manual boxs are very rare to find in australia mate. You might need to source one from japan buddy.

it would be cheaper to get one from kempy's in NZ and ship it over than from japan.

nvr2low · Post by **nvr2low** » Mon Mar 30, 2009 1:53 am

oh ok mate i was just pointing out it is so rare to find a manual box. wreckers sell them but only part of half cuts mate.

FTEvolution · Post by **FTEvolution** » Mon Mar 30, 2009 6:48 am

RichardB wrote:
nvr2low wrote:hey mate manual boxs are very rare to find in australia mate. You might need to source one from japan buddy.
it would be cheaper to get one from kempy's in NZ and ship it over than from japan.

Hey Richard, if necessary check out www.trademe.co.nz and I can help where I can to get one to you...

Post by **Bennoz** » Mon Mar 30, 2009 7:52 am

Try Mark Gibbs Panelhouse

www.panelhouse.com.au

RichardB · Post by **RichardB** » Mon Mar 30, 2009 8:36 am

Bennoz wrote:Try Mark Gibbs Panelhouse

www.panelhouse.com.au

Thanks Ive dropped them a message