Page 1 of 1
Thickness of rear light plastic?
Posted: Fri Nov 23, 2007 2:29 pm
by mr-charisma
Hi, as the title suggests, I am wanting to know how thick the plastic cover of the rear lights is ... has anyone baked the rear lights before to take them off or knows roughly how thick it is?
Posted: Fri Nov 23, 2007 3:14 pm
by MissxFTO
1cm would be my rough guess my left light has a chip in the reverse section! >.<
Its probably not even that
Posted: Fri Nov 23, 2007 3:25 pm
by mr-charisma
i hope it's 1cm ... that'd be heaps ...
Posted: Fri Nov 23, 2007 3:38 pm
by robsta
its about 2-3mm, just went and measured it on my car
Posted: Fri Nov 23, 2007 4:22 pm
by Richy
1cm would be my rough guess my left light has a chip in the reverse section! >.<
thats bullet proof
Posted: Fri Nov 23, 2007 4:44 pm
by manofwood
i've pulled them apart, same thickness on inside of lens as the outer edge, 2-3mm
Posted: Fri Nov 23, 2007 11:23 pm
by maggsy
may i just ask what u are requiring these measurements for
Posted: Sat Nov 24, 2007 12:33 am
by cHONGA
When you do do it take your time to seperate cause i tried to bake em to tint the inners and snapped it staight down the middle
and dont forget about em in the oven i did when i done the other light and it melted
so overall it was a complete failure, ohwell they were pretty rooted neway, im gonna get those decals like sammi's easier.