Thickness of rear light plastic?

mr-charisma · Post by **mr-charisma** » Fri Nov 23, 2007 2:29 pm

Hi, as the title suggests, I am wanting to know how thick the plastic cover of the rear lights is ... has anyone baked the rear lights before to take them off or knows roughly how thick it is?

MissxFTO · Post by **MissxFTO** » Fri Nov 23, 2007 3:14 pm

1cm would be my rough guess my left light has a chip in the reverse section! >.<

Its probably not even that

mr-charisma · Post by **mr-charisma** » Fri Nov 23, 2007 3:25 pm

i hope it's 1cm ... that'd be heaps ...

robsta · Post by **robsta** » Fri Nov 23, 2007 3:38 pm

its about 2-3mm, just went and measured it on my car

Richy · Post by **Richy** » Fri Nov 23, 2007 4:22 pm

1cm would be my rough guess my left light has a chip in the reverse section! >.<

thats bullet proof

manofwood · Post by **manofwood** » Fri Nov 23, 2007 4:44 pm

i've pulled them apart, same thickness on inside of lens as the outer edge, 2-3mm

maggsy · Post by **maggsy** » Fri Nov 23, 2007 11:23 pm

may i just ask what u are requiring these measurements for

cHONGA · Post by **cHONGA** » Sat Nov 24, 2007 12:33 am

When you do do it take your time to seperate cause i tried to bake em to tint the inners and snapped it staight down the middle

and dont forget about em in the oven i did when i done the other light and it melted

so overall it was a complete failure, ohwell they were pretty rooted neway, im gonna get those decals like sammi's easier.