Changed stepper motor, now won't start

Post by **bjk** » Mon Jun 12, 2017 1:52 pm

So car has been unhappy. Sounds rough, idle will hunt between 600-800 after a cold start, has been stalling when coming to a stop, or the revs drop to 500rpm before recovering.

Kiz has a spare black stepper, so I pulled off mine and put it on, and now the car will turn over, rev up and then it drops off and dies. Halp?

mezje · Post by **mezje** » Mon Jun 12, 2017 2:05 pm

Have you reconnected all the plugs/looked at plugs you may have disconnected?

Is it in the correct way with the o-ring?

Sahin · Post by **Sahin** » Mon Jun 12, 2017 2:12 pm

Let it relearn, it'll take ages some times

Post by **bjk** » Mon Jun 12, 2017 2:28 pm

Only disconnected the one plug. Mike thought it might have been a missing o-ring but there was one there, just checked.

So I should just take it out for a drive again like after battery was disconnected?

Post by **bjk** » Tue Jun 13, 2017 1:55 am

Fixed, huzzah. Did need a bit of a drive. Nowhere near as long as for battery. Backed it out of the driveway and down the street and it was already not stalling but took it out for a half hour or so for good measure.

evo-gsr · Post by **evo-gsr** » Wed Jun 14, 2017 7:08 pm

Typical slow learning Mitsubishi!

Post by **Supplanter** » Wed Jun 14, 2017 9:09 pm

evo-gsr wrote:Typical slow learning bjk!

Post by **bjk** » Wed Jun 14, 2017 9:13 pm

Supplanter wrote:
evo-gsr wrote:Typical slow learning bjk!

This.

evo-gsr · Post by **evo-gsr** » Thu Jun 15, 2017 7:23 am

FTO AUSTRALIA

Changed stepper motor, now won't start

Changed stepper motor, now won't start

Re: Changed stepper motor, now won't start

Re: Changed stepper motor, now won't start

Re: Changed stepper motor, now won't start

Re: Changed stepper motor, now won't start

Re: Changed stepper motor, now won't start

Re: Changed stepper motor, now won't start

Re: Changed stepper motor, now won't start

Re: Changed stepper motor, now won't start