Exact location of clutch cylinder / reservoir?

[Rob Furniss]

It's the bit near the brake servo that i'm interested in as I need to make sure the supercharger bracket will clear it (and if not redesign it for the manuals).
Anyone have a good pic or some measurements like X cm from this and Y cm from that?
Was thinking someone who's done a manual conversion may have the info.

And what's the difference between master and slave - are there two?
Cheers

[Sahin]

The slave is on the gearbox itself

[Rob Furniss]

Ah good thanks Sahin, that's well out of the way then.
Anyone have a guide for fitting the master when doing a conversion or a template for cutting the bulkhead etc?

[Bennoz]

Pretty sure it's in the manual conversion doco.

http://ftoaustralia.com/downloads/Manua ... on_DIY.pdf

[Rob Furniss]

Thanks Ben, it is.