What work did you do on your car today?

[rock_it]

What did you use? I'm assuming from the masking that it wasn't just a tint, but I could be wrong.

Clear paint tinted with a splash of red ...

[rock_it]

You also may be able to buy ...



But not available everywhere, as people only tend to use the black tint...

[Supplanter]

Drove it. For the first time in two months. To the car wash. To wash the bonfire ash off it.

[PHIL069]

Drove it. For the first time in two months. To the car wash. To wash the bonfire ash off it.

Did you have flat spots on your tyres?

[destinationtoby]

Drove it. For the first time in two months. To the car wash. To wash the bonfire ash off it.

Did you have flat spots on your tyres?

I was wondering about this today actually, is it bad for tyres to leave a car sitting for to long? Mines been parked for a few months now.

[Vectose]

Restored a Project F lens.

Need to go back and redo 1500 and 2000 as I rushed through them and I just did a light buff with Scratch X

But overall I'd say it's an improvement.
Still has a slightly yellow tinge but not that noticeable.

And the one I restored was worse off than that other one in the pic to begin with. Someone had used superglue to stick it back on and had runs going down it.

Started off with 180 grit and went through to 2000.

Even at 180 it was a pain removing the yellow tinge and sun cracks in the surface. I didn't even remove them all.




If there is enough interest, I will look into having copies of the lenses made, as well as making moulds for the Project F lights.

I will be making circular LED boards for them.

[bjk]

It's a race to release aftermarket tail lights.

[Technikhaus]

Nice, and somebody needs to reproduce some!

[Bennoz]

Lol, f*cken project Fs. I've said it before & I'll say it again, get the lenses down to an injection moulder for reproduction.

Will be quite happy to eat my hat when someone actually gets a restored set put in their car & actually look good!

[Vectose]

These aren't going on my car. :lol:

[Daniel2019]

Lol, f*cken project Fs. I've said it before & I'll say it again, get the lenses down to an injection moulder for reproduction.

Will be quite happy to eat my hat when someone actually gets a restored set put in their car & actually look good!

That's what I was going to do.. but then like many other things they got thrown in the back of the garage in the "I'll do it later" pile.. need more hours in the day

[destinationtoby]

Lol, f*cken project Fs. I've said it before & I'll say it again, get the lenses down to an injection moulder for reproduction.

Will be quite happy to eat my hat when someone actually gets a restored set put in their car & actually look good!

Whoever bought mine said they were doing this... Can't remember who Someone on here

[Vectose]

Lol, f*cken project Fs. I've said it before & I'll say it again, get the lenses down to an injection moulder for reproduction.

Will be quite happy to eat my hat when someone actually gets a restored set put in their car & actually look good!

Whoever bought mine said they were doing this... Can't remember who Someone on here

Pretty sure I have yours now.

[Bennoz]

[destinationtoby]

[destinationtoby]

I really wanna see this c**t eat his hat

[SchumieFan]

I gave dwayne the lense molds that i bought so he can make reproductions for this very purpose! Hit him up if you need a set!

[Scorpionwally8]

So I decided to have a go at polishing the headlights here are the results before and after

Before


After

[PHIL069]

Nice job

[Bennoz]

Nicely done