Interior bulb fitting ?????
Moderators: IMC, Club Staff
-
- Newbie
- Posts: 17
- jedwabna poszewka promocja
- Joined: Mon Aug 19, 2013 7:28 pm
Interior bulb fitting ?????
Does anyone know a easy way to change your interior light bulbs in the mirror ? I have taken one out and will be replacing it with led's however it seems really difficult to get the bulb back in and I wondered if there was any technique to doing this ? Thanks
- kiz
- SA Coordinator
- Posts: 2178
- Joined: Wed Nov 09, 2011 10:09 pm
- Location: Adelaide, South Australia
Re: Interior bulb fitting ?????
As in the bulb wont go back in or the led wont physically fit into the space?
There are two types of people on forums; those that give helpful advice, and the others
1998 Mitsubishi FTO GPVR AERO
1998 Mitsubishi FTO GPVR AERO

-
- Newbie
- Posts: 17
- Joined: Mon Aug 19, 2013 7:28 pm
Re: Interior bulb fitting ?????
Well just fitting it back really, its kind of at a odd angle and trying to look underneath the mirror sat on the edge of the seat is kind of difficult. I wondered if it was easy to take the mirror off to just put them in facing down like on a table rather than trying to get it in looking underneath ?
- Vectose
- Forum Moderator
- Posts: 3952
- Joined: Sun Nov 28, 2010 8:45 pm
- Location: Newcastle
Re: Interior bulb fitting ?????
Mirror comes off with a simple twist.
Bennoz wrote:A whoooole lot 'o jismTechnikhaus wrote:What is in said Bens big penis by the way?
- shadowarrior
- Tightarse
- Posts: 2703
- Joined: Thu Oct 27, 2011 4:48 pm
- Location: Gold Coast
Re: Interior bulb fitting ?????
How many Jack's does it take to change a light bulb? 

- TomHenman
- Grease Monkey
- Posts: 100
- Joined: Thu Feb 28, 2013 8:07 pm
- Location: Wollongong
Re: Interior bulb fitting ?????
I just did mine and I just gripped the edge of the festoon bit with long nose pliers.
But it is a pain especially on mine cause the socket attachment had corroded and didn't want to stay in place.
Also the LEDS I got seemed slightly shorter than the stock ones and wouldn't hold, so had to make some little aluminium foil crowns for each end so it fit in snug.
But it is a pain especially on mine cause the socket attachment had corroded and didn't want to stay in place.
Also the LEDS I got seemed slightly shorter than the stock ones and wouldn't hold, so had to make some little aluminium foil crowns for each end so it fit in snug.
-
- Newbie
- Posts: 17
- Joined: Mon Aug 19, 2013 7:28 pm
Re: Interior bulb fitting ?????
Ahhh i see, mine seem's to be the same with a short led bulb so thats very helpful as that would of been my next question. thanks