decided to paint everything in chronological order:
I am now 25 years old. FTO is my 4th car. Prior to this were:
RUSSIAN VAZ 21099:

next Ford Escort 1.3

next Opel vectra A 2000.
interesting car. 150 hp.
Break the timing belt and a long repair

then sold it. sap money. Looked PRELUDE 5, Celica T20, eclipse 2g, but chose FTO))))
I bought it for $ 9000
replacement of consumables

in the first week had to be fined $ 150 and bring down drunken pedestrian. Ran out on the road is not in a crosswalk. In the blood, he had a few ppm of alcohol. The speed limit, I did not break. What does find my braking distance. I was found guilty, and pedestrian reimburse replacement glass.

then pulled the roof and the space between taillight glossy black vinyl. $ 220

Replace cartridge antenna. I broke down the old cartridge vandals
was in a small accident in the parking lot.
lamp purchased.
bumper welded. Decided to temporarily use stikerbombing
trained on a laptop)
bought fresh taillight and toned to blend in with the vinyl strip
changed the radio

in the past
continue following such purchase
make podium.sewn-bad. But the money for it did not take
Next is the replacement of the timing belt, pump, all seals (5 pcs.), rollers, thrust bearing, strikers
next, purchase of all brake pads, all guide carriages (8 pcs.), repair kits(4pcs.), rear brake discs. Full recovery
give the back seat on the waist. do vibration and noise isolation
Takin back sofa
Altering am on the seat.
friend gave me a seat heater on a new Nissan Murano.
Master sew seat heater inside
It seemed to me that these terms are not removed in 1996

alter door card. Do double vibration isolation and noise of doors
result
replacement foglights and steering tube
Automatic filter change. Replacing motors idling on throttle
Next, I bought a restyled bumper(250$) and original xenon headlights(300$)
In Angel Eyes headlights set
replaced by a second tube power steering
Reinstall the original sound signals.
replacing outdated electrical tape
redid the wiring for lights and turn signals
changed the cracked part of the air intake
plug adapter for additional sensors and paved the wire for them
bought plastic sill and installed them, hung front bumper
replacement of spark plugs (6 pcs.), hydraulic lifters (24 pcs.), gaskets valve covers (2 pcs.), gaskets, candle rings (6 pcs.), intake gasket
completely went over the rear axle
replaced the old cardboard trunk
more engaged in body repair.
complete removal of rust, welding, machining and corrosion epoxy primer coating
Full painting, assembling, installing ceiling
purchase and installation of the original protection
Replacement outer Joint boot
Replacement glass exterior moldings
relamping
replaced by two-piston front calipers
certainly, many things forgotten ....
OFFTOP:
