CODE READER

Paddyman · Post by **Paddyman** » Tue Aug 24, 2004 10:33 pm

Does anyone on here know of a code reader that is compatible with the FTO. Is the FTO OBDII compatible with generic code readers.
I have just bought a MUT-II but when it arrived the software card was missing.
Was thinking of something along this line. http://www.launch-tech.com/english/prod ... e=20AP002C

Anybody have any ideas.
Does anyone know where I might get the MUT-II card from.

Rory

RichardH · Post by **RichardH** » Wed Aug 25, 2004 12:28 am

Dunno about OBDII - I think it's proprietary link-up to the MUT-II.

But you can just connect one little pin to ground in order to get the engine ECU error codes displayed...

http://www.ftowa.com/html/workshop/workshopart07.html

Hope this helps!

- Rich

Paddyman · Post by **Paddyman** » Wed Aug 25, 2004 1:01 am

Cheers Rich,

I was aware of this from browsing around the site, but what I had hoped to do was have a constant display for error codes when present.

As I said I have a MUT-II but the software is missing.

Rory