Tips on installing el plate.

bass_twitch · Post by **bass_twitch** » Sat Oct 22, 2011 11:19 am

As per title, just got a slam panel with el plate,
Any tips for installation??

EDIT: I've gotten this far.. It's just not wired..

Post by **Shhtuart** » Sun Oct 23, 2011 5:03 pm

It's all soldered up and ready to go

The black alligator clip hooks up to your negative terminal and the red one to the positive.

bass_twitch · Post by **bass_twitch** » Sun Oct 23, 2011 10:58 pm

Shhtuart wrote:It's all soldered up and ready to go

The black alligator clip hooks up to your negative terminal and the red one to the positive.

There wasn't a red clip, no worries though I'll make it work

What's the white wire??

Post by **Shhtuart** » Tue Oct 25, 2011 8:11 pm

Just ignore the white one, it's to hook up other EL plates to.

Did the red clip fall off? They were cheap as, just go to any electrical store and get a new one for 30c and solder it on.

I also forgot to say, do not run the wires directly past the engine, try and snake it away from it. It will melt the insulation from the cable

bass_twitch · Post by **bass_twitch** » Tue Oct 25, 2011 9:37 pm

Shhtuart wrote:Just ignore the white one, it's to hook up other EL plates to.

Did the red clip fall off? They were cheap as, just go to any electrical store and get a new one for 30c and solder it on.

I also forgot to say, do not run the wires directly past the engine, try and snake it away from it. It will melt the insulation from the cable

Haha
No probs, I wasn't planning on running them past the engine anyway

I'll test the plate on the weekend

Hey Dwayne, if you see this thread, I distinctly remember yours being connected to a switch? Or something? Am I remembering right?

fto-007 · Post by **fto-007** » Thu Oct 27, 2011 10:14 pm

Hi slam panel looks great where did you get it from?

FTO AUSTRALIA