Hey guys and girls

FtoSam · Post by **FtoSam** » Thu Sep 04, 2008 7:17 pm

Edited to keep on topic...

Check General for other posts..

xSlurpee · Post by **xSlurpee** » Thu Sep 04, 2008 7:19 pm

Thanks mr moderator

I Suck Cock

FtoSam · Post by **FtoSam** » Thu Sep 04, 2008 7:26 pm

xSlurpee wrote:Thanks mr moderator

I Suck Cock

Keep it on topic please mate....

and gross

xSlurpee · Post by **xSlurpee** » Thu Sep 04, 2008 7:45 pm

LMAO sam you homo ....

Nice wide body kit ... is there a price on that kit? estimate price is good enough

Criss · Post by **Criss** » Thu Sep 04, 2008 7:59 pm

SAM..........
why you have to do this to me......

anyways..........i might buy this kit if someone can make exactly the same
but it depends on price for sure

Post by **aza013** » Thu Sep 04, 2008 8:11 pm

all I will say is it will cost a sh*t load of $$$$$ to get it made up.
but it would look cool.

Jamie · Post by **Jamie** » Fri Sep 05, 2008 10:26 am

haha i'm currently working on making a once off of this kit too
I bet once one of us ends up getting it right everyone will start doing it then goes away the Ã¼nique factor
Once completed i reckon all up it'll end up costing me 10-12 grand for the kit that includes repainting the fto white.

@ Taeivon_Rep

I wouldnt worry about the unique factor too much, because the kit is hand made and a once off(unless someone makes a mould) it wll always be unique.

Are you planing on making a mould because I think 10-12k is way over the top. (I estimated that I could do it for around 5k)

I problem I ran into was the rear guards. The rear guard, 'C' pillar and the roof are all one panel so making a replacement panel would be out of the question. Do you have any ideas for the rear guards. Or anyboy else.

Taeivon_Rep · Post by **Taeivon_Rep** » Fri Sep 05, 2008 4:22 pm

Jamie wrote:haha i'm currently working on making a once off of this kit too
I bet once one of us ends up getting it right everyone will start doing it then goes away the Ã¼nique factor
Once completed i reckon all up it'll end up costing me 10-12 grand for the kit that includes repainting the fto white.

@ Taeivon_Rep

I wouldnt worry about the unique factor too much, because the kit is hand made and a once off(unless someone makes a mould) it wll always be unique.

Are you planing on making a mould because I think 10-12k is way over the top. (I estimated that I could do it for around 5k)

I problem I ran into was the rear guards. The rear guard, 'C' pillar and the roof are all one panel so making a replacement panel would be out of the question. Do you have any ideas for the rear guards. Or anyboy else.

I was looking into that also and decided best to at least start on the front bar, im thinking of just chopping a facelift front bar and custom making the rear wing coz its huge. I reckon my budget is a tad over but was going to over budget a lot rather than fall up short. whatever is left over will go into some race rims and rubber to fit under those guards. Check back in a coupla months

i should be getting there then. lol should race to see who can make the first copy of it!