air ram pipe question ??

tintin · Post by **tintin** » Mon Feb 25, 2008 2:39 am

ive had a play with the new air ram cone to day got the ally pipe the right lenght . i took my iduction pipe a part to use the rigrt angul bends looking at it ill ether have to cut the pipping down and use 3 90 degrees pipes or 1 90 degree and a 180 degree or 2 90's and a 20 degree kink

what do you think will be best?

thanks
martin

mr-charisma · Post by **mr-charisma** » Mon Feb 25, 2008 5:08 am

why you using the alloy piping for an air ram? should get yourself a length of some plastic flexi hose with a decent diameter.. not only is it lighter, but its more forgiving in the bends..

anyways... 2 90's with a 20 degree kink is the lesser of three evils..
depends on your setup as to what oyu can get away with i spose..

tintin · Post by **tintin** » Mon Feb 25, 2008 7:52 am

mr-charisma wrote:why you using the alloy piping for an air ram? should get yourself a length of some plastic flexi hose with a decent diameter.. not only is it lighter, but its more forgiving in the bends..

anyways... 2 90's with a 20 degree kink is the lesser of three evils..
depends on your setup as to what oyu can get away with i spose..

cheers.

the reson im not using flexi pipe is cos its got ribs in so the air wont flow as much . say as silicone hosing and ally pipe

mr-charisma · Post by **mr-charisma** » Mon Feb 25, 2008 2:38 pm

fair enough, 2 easy .. whats the biggest flexi pipe you can go vs the biggest alloy pipe?

tintin · Post by **tintin** » Mon Feb 25, 2008 9:02 pm

mr-charisma wrote:fair enough, 2 easy .. whats the biggest flexi pipe you can go vs the biggest alloy pipe?

im using 3" / 76mm alloy pipe with 3" / 76mm silicone hosing