I'd be looking to cut out the rust & repair & repaint the affected panels before replacing the seals... do you have a blockage in the drain hole of your doors?
um.... the stock speakers are how old now? lol
i doubt this is going to happen to your new speakers in the next couple of yrs.
check to make sure the drainage things are fine, and rust proof the metal bits of your speakers if u r that worried.
or tape a couple of those silicon moisture absorber thingos inside your door panel (u know the ones u find in shoe boxes etc), but make sure they r not going to get wet (so tape them to somewhere high up on the panel)
kiz wrote:
silverGPX wrote:This requires a thread? lol
There's potential for a thread about anything on FTO Australia
Haha mine were like that too when i pulled 'em out. Don't forget japan's an island too, things would rust a lot quicker over there due to the air i'd say.
As i did, and anyone should do, when you replace your speakers stick the new ones in a plastic bag before you re assemble the door, but put a few holes in the bottom, that way if any water leaks into the door it wont damage your speakers.