Unifilter Foam Pod Filter + Plastic heatshield

khunjeng · Post by **khunjeng** » Wed Dec 27, 2006 11:48 pm

Hi Guys

I took off my Unifilter pod filter and shield...

Its an oiled foam type as used by UAS in their FTO intake shown here:
http://www.300zx.com.au/pricelists/Gene ... odkit2.jpg

These are fully re-usable, I have cleaned this one so it is now like new. Comes with the adaptor to fit onto the stock intake pipe and brackets to hold it up...

Will throw in a bottle of the re-oil from Unifilter which is $20 a bottle for free.

Makes an awsome induction sound....

I am looking for $120 delivered anywhere in Aus..

Check out the Unifilter site if you wanna know more about theri products:
http://www.uniflow.com.au/

EURO · Post by **EURO** » Thu Dec 28, 2006 11:13 pm

did the UAS heat shields have a lid as well? would u consider selling just the shield?

khunjeng · Post by **khunjeng** » Fri Dec 29, 2006 12:16 am

EURO wrote:did the UAS heat shields have a lid as well? would u consider selling just the shield?

not really...whoever gets the pod needs the shield otherwise its pointless..

I'm not fussed if I keep it or sell it..but it needs to all go together, sorry mate. Juts buy the shield from UAS if u want one. there are like 100.

ed · Post by ed » Mon Jan 01, 2007 3:44 pm

would it fit a gr?

Post by **Supplanter** » Mon Jan 01, 2007 4:40 pm

I think the filter end of the intake pipe needs to be cut to fit the GR MAF sensor box thingy. (that is the technical term for it).

khunjeng · Post by **khunjeng** » Mon Jan 01, 2007 5:15 pm

Supplanter wrote:I think the filter end of the intake pipe needs to be cut to fit the GR MAF sensor box thingy. (that is the technical term for it).

yeah I think he is right...dunno never seen the inside of the MAF