FTO AUSTRALIA

Need the two bulbs and holders that they sit in from behind the clock. I blew them when changing my dials and have since lost them from my cup holder. Any one got them going spare plase?

Thanks, AJ.

Need the two bulbs and holders that they sit in from behind the clock

Can help you out there. Have plenty of spares.

cheers dstocks

thanks dstocks. PM sent.

dstocks wrote:

Need the two bulbs and holders that they sit in from behind the clock

Can help you out there. Have plenty of spares.

cheers dstocks

all of my bulbs are very dim and i cant see them at night (barely, need my eyes to adjust to the dark to be able to see my speed basically)

now how can ALL of the bulbs be so "weak" at the same time? and do i have to repalce them all?

if i do, can u help me out too lol

Look at your dimmer switch. These are added at compliance time. Likely yours is a bit dodgy or the wrong rating

dstocks wrote:Look at your dimmer switch. These are added at compliance time. Likely yours is a bit dodgy or the wrong rating

ya I just took mine off cos it was suspect...

you need the holders and you can wire in some wedge bulbs to make it brighter...I need to do my climate control unit but just been lazy..

Easier just to replace the dimmer. Go to a wrecker and pick one you like the look of. A Mitsubishi one would be the best bet as it would be more likely to be rated correctly. Better still measure the current in yours and ill check the one in my FTO and see if they are similar (my lights are fine). Take the multimeter to the wreckers with you.

dstocks wrote:Look at your dimmer switch. These are added at compliance time. Likely yours is a bit dodgy or the wrong rating

i dont have a dimmer switch

Seriously i ran my hands over every part of my interior and even into places i couldnt see and couldnt find it.. i dont have a dimmer switch