Page 1 of 1
Dash Dial Kit..
Posted: Tue Nov 21, 2006 11:58 am
by leinad
Hi,
I have managed to stop my heat and RPM gauge from working on my FTO
after replacing the facia for the second time.
Am I able to purchase the hole thing in one kit, or do will I be better off getting somone to repair the ones that arn't working?
I think I pushed them in to hard or something as they dont respond..
Posted: Tue Nov 21, 2006 1:50 pm
by Panelhouse
what exactly are you after? would you want to purchase a whole cluster?
Nathan,
Panel House
Posted: Tue Nov 21, 2006 2:03 pm
by Supplanter
Have you tried pulling the needles out a bit? Use a teaspoon as a lever
Posted: Tue Nov 21, 2006 2:14 pm
by leinad
Panelhouse wrote:what exactly are you after? would you want to purchase a whole cluster?
Nathan,
Panel House
Yeah if I can just purchase the hole lot and just replace it that would be the easiest. Hoepfully get a alluminum look
Posted: Tue Nov 21, 2006 2:16 pm
by leinad
Supplanter wrote:Have you tried pulling the needles out a bit? Use a teaspoon as a lever
Yeah, thats how I got them out the first two times
I have tried to gently place the needles back in, the RPM one doesn't seem to grab anything, just like it is sloppy.. although it has slowly moved from 0 to 7rpm over 2 weeks.
Thanks guys
Dan
Posted: Tue Nov 21, 2006 6:25 pm
by khunjeng
Panelhouse wrote:what exactly are you after? would you want to purchase a whole cluster?
Nathan,
Panel House
hey man have u got whole clusters?? I want one for my new dial setup I am planning..
Posted: Wed Nov 22, 2006 9:28 am
by Panelhouse
we dont have the style you are showing in the picture there, we have mivec ones for $125 or a strandard type for $100.
Nathan,
Panel House
Posted: Wed Nov 22, 2006 10:25 am
by leinad
Panelhouse wrote:we dont have the style you are showing in the picture there, we have mivec ones for $125 or a strandard type for $100.
Nathan,
Panel House
Lifesaver!
Nah I don't want the white facia, just used the image as an example of what isn't working.
I'll PM you my details and organise payment if this is possible.
I need the MIVEC version
Are you able to get any of these at all;
Thanks
Daniel
Posted: Wed Nov 22, 2006 10:34 am
by Bennoz
All that dash bling stuff is available thru kmc. He is a member here, so just PM him.
http://www.kmc-products.com for pics of the bits.
And...
Posted: Wed Nov 22, 2006 10:40 am
by dstocks
And I have dealt with him before (on dash stuff) and he provides good service!
Posted: Wed Nov 22, 2006 2:34 pm
by leinad
Thanks!
