Page 1 of 1
Quick question on Rear plate?
Posted: Wed Jul 26, 2006 7:31 pm
by messy
Hey everyone, just a really quick question its probs dumb just wanna see what i can do about it.. Just got my import fto today, rego all done.. got my WA plates but the rear plate is a little long. i see ppl have bent theres or trimmed them.. what should i do?? any suggestions would be greatful
-dan
Posted: Wed Jul 26, 2006 7:38 pm
by Hobbsie
whatever u reckon looks good.. jus make sure the numbers are clearly visible
Posted: Wed Jul 26, 2006 9:17 pm
by jonowong
dont trim it...
just find a metal edge... and hammer it so its a 90 degree angle...
Posted: Thu Jul 27, 2006 12:54 am
by Aspenmai
I had same problems
I just got the longer screws
I did try to cut/shave the sides... so it fit just inside the edges
I have a coloured plate and looks silly if you bend it
i'll probably change it later in fear of it falling off..
but for now it seems to stay
just make sure its secure...
Posted: Thu Jul 27, 2006 10:50 am
by SILVERFISH
just screw it down tight... it'll bend to fit