Page 1 of 1
KMC - V4 Dials Installed
Posted: Tue Jan 17, 2006 11:18 pm
by khunjeng
Hi Guys
For everyone who just bought the new dials form KMC - I ordered mine earlier and I have just installed them...just waiting for the caps!! you will see that the caps will be awsome...
I have a video also ..where were can hear my new exhuast also!
2mb -
http://www.users.on.net/~chris.law/V4dials003.avi
Not great pics cos I just took them (at night) so the lighting was rooted...however everyone can check them out on the Cruise if your in Vic...[/url]
Posted: Tue Jan 17, 2006 11:40 pm
by Rocco
Sounds and looks great mate
Posted: Wed Jan 18, 2006 12:01 am
by dj_ules
they look awsome.
Posted: Wed Jan 18, 2006 12:11 am
by FTO338
Looks great Chris. You going to have a laugh when u see mine this Sunday, mine is like yours atm except the silver isn't as shinny cause its just a spray on.
Damit i just realise whats the different between V3 & V4, V3 goes up to 10krpm.
Posted: Wed Jan 18, 2006 7:16 am
by khunjeng
lol I will have them all out again 2nite...I need to fix the volt meter a bit cos the needle doesn't seem to be working properly...but apart form that it was pretty easy and look about 1.5hrs to complete.
Also I will clean the metal and make it look more shiney!! I think it looks great also...now yime for the LEDS!
Posted: Wed Jan 18, 2006 9:48 am
by FTO338
So did you order the same LED i've got, or you ask for ultra bright with wide angle?
Posted: Wed Jan 18, 2006 2:24 pm
by dj_ules
hmmm .. i have a dimmer for my dash.. to make it brighter or darker.. if i put those wide angle LED's. will my dimmer still work with the led's or not ?
Posted: Wed Jan 18, 2006 2:30 pm
by FTO338
All imports must be install a dimmer for compliance. And the answer for your question is no
Posted: Wed Jan 18, 2006 2:56 pm
by robsta
FTO338 wrote:All imports must be install a dimmer for compliance. And the answer for your question is no
I cant find my dimmer anywhere
Posted: Wed Jan 18, 2006 3:07 pm
by FTO338
Well then your FTO is not road worthy according to compliance........
Posted: Wed Jan 18, 2006 3:55 pm
by BuCkEt
FTO338 wrote:Well then your FTO is not road worthy according to compliance........
done done done.....
To be honest I think whoever complied mine just shoved the switch in there and never hooked it up.
Posted: Wed Jan 18, 2006 4:15 pm
by kid_dynamite
Dimmer isn't required in NSW anymore, and hasn't been required for a few years now
Posted: Wed Jan 18, 2006 4:16 pm
by robsta
mad....
ohwell if I get done for it then I will do something about it, til then who cares
Posted: Wed Jan 18, 2006 4:21 pm
by ANBU_fto
are they the white or blues?
Posted: Thu Jan 19, 2006 5:55 am
by Dr_Jones
FTO338 wrote:All imports must be install a dimmer for compliance. And the answer for your question is no
Are you sure about that. I was under the impression that LED's could be dimmed without a problem.