FTO AUSTRALIA

hi,
this would be strange for u but could anyone whos got these make a tracing of it for me. im trying to make one from a cf sheet that ive got. need it so i do a good job . please

comeon im sure one of u have these on their . make me a tracing please

I give you a better idea, why don't you use the "carbon" technique, & then cut it out.

Just in case you don't know what a "carbon" technique is, is what we did in primary school, put a piece of paper on top of the instrument cluster, & then run over it with either carbon dust or use coloring pencil & you get the out line sketches of the panel.

hehe too much effort. found it anyway . if someone wants it http://fto.servepics.com/images/fto-dials.gif

and this is what i came up with

what do u think????

i think i shal do the same.....

looks really nice and proffesional shue. how did you cut it so straight?

Looks really good

i just used a hobby knife. its got kinda rough edges though

sandpaper ?

thanks boris. y dint i think of that .

hobby knife? hmmm... you still would need some steady hands. i know if that was me i would had a spazz attack in my hand while cutting and end up cutting the whole thing in half. hahaha. nice job once again.

good job, think you missed out the small hole for the reset pole.

doesnt the pole come out of the dial not the surround???

nah i missed it