Page 1 of 1
stero cage part number?
Posted: Wed Dec 08, 2004 8:49 pm
by paladin
hi folks, i am just after the part number for the stero cage in the FTO, that is the bit behind the plastic front which actually holds the stero in place
either that or someone whos selling one ?
Posted: Wed Dec 08, 2004 9:04 pm
by D-TRAIN
Is that the part that goes right around the gear shift also?
Posted: Thu Dec 09, 2004 7:58 am
by paladin
dont know if it does that becuase i havnt seen it !
basicly it goes, from waht i can tell
plastic face: sterocage that holds stero: frame work which holds the plastic side pannels on and the shifter in place
Posted: Thu Dec 09, 2004 8:07 am
by Boris
I could reccommend you visiting a smash repairer, they have good contacts. It may cost slightly more, but atleast you possibly can get it quicker.
Try these guys, they do lot's of imports, and there working on my car at the moment.
Fuller Brothers
Park Street, Belconnen
Both the two ladies at the counter, and Daniel the manager are very helpfull.
Posted: Sat Dec 11, 2004 7:28 pm
by payaya
ah i use to have them! a lot of mitsu dealers have them! ring the dealer they would have it on the CAPS program.
Posted: Sat Dec 11, 2004 9:26 pm
by afterburner
I have CAPS - the closest thing I can find are the two brackets which you screw to the sides of the stereo which then bolt into the dash frame. In CAPS, these are referred to as:
Bracket - Audio Equipment LH, part number MB874343
Bracket - Audio Equipment RH, part number MB874344
PNC number 85966
That is for a single DIN stereo
Is this what you were after?
Posted: Mon Dec 13, 2004 12:12 am
by paladin
f**k i have those!
ROFL
thanks guys