FTO AUSTRALIA

Hey Guys,
One of my belts have frayed on my engine and is holding on by a few threads

I think it is the Airconditioning and Power Steering belt as you can see it by looking straight down the left hand side of the engine (95 GPx Mivec manual).

I need to know the part number if anyone knows it as Im having problems finding one ?

Your help would be appreciated .....

Toni

Hey toni

I had to replace mine few months ago,
Culdn't find a OEM part so used a similar one ( i can re-call my search! that was a trip )

Ive got the part/belt no. in the Car.. will let you know 2morrow...

-shannon

really? they arent that hard to find
sure your local autopro or whatever may have to order it in, but last time i did this, within a few hours they had one waiting for me

the part no's are
alternator belt- 4PK945
power steering - 6pk1070(though you'll prolly not find a 1070 and use a more readily available 1080 instead, makes no difference, thats what the adjuster is for)

SilentBob

Thanks guys will pass this information onto my mechanic he probably knows jus wanted to make things a little easier and cheaper by picking one up myself !

Hey toni,
Sorry bout the late reply

Neway, Silent bob is dead right.
I couldnt find the 6PK1070, all i could find was a DAYCO 6PK1065. From repco if i can recall.

Its a bit of a tight fit but once its on its fine (a 5ml difference)
Had mine on for ages now and its sweet.

Good luck.

Thanks for all your help guys

how much did it cost for you guys to fit it (including parts)??

the belts usually cost around 40-60 for both, fitting ranges about 50-80 i guess, its not that hard to do it your self though , there isa guide @ www.mitsubishi-fto.org however its down atm

cost me $50 to purchase and fitting of genuine Mitsubishi belt at Northern Mitsubishi at Preston.
This was the only thing they were confident to do with my FTO. I dont recommend them, and never go back there again after 2 services.

bando or brando, are about $28, made in japan for a 6pk

oh.... labour sounds more expensive than the part itself......... but still big variation in prices............

well labour should include :

hoist time - $30
Mech- 20 mins( 20/60 x 75) = $25
Materials - ?? $2 $3

so it should be around 50 60 for labour... plus parts. so around 80 90 for everything all up

hi guys, i just go it done at MIDAS in Coopers Plains QLD.
Cost $40 (part + labour)... for DAYCO 6pk.... anyone in QLD wanna get it done, go there!