Page 1 of 1
Idle problems
Posted: Fri Feb 28, 2014 2:50 pm
by Daniel2019
Yes I know its been covered..
Basically my idle will sometimes stay up at 2,000rpm, sometimes more.
Usually it's fine but this morning started up at 2,500 from cold.
Not an idle screw issue obviously.. car is fine when in gear. Not so good with clutch in or in neutral.
I'm thinking vac leak of some description. Have a new stepper coming.. any other suggestions?
Re: Idle problems
Posted: Fri Feb 28, 2014 3:04 pm
by rock_it
Shoulda bought Bobby ...
Lol, sorry man couldn't resist...
But as the tree said to the lumberjack .. I'm stumped..
Re: Idle problems
Posted: Fri Feb 28, 2014 3:30 pm
by kiz
Mine occasionally idles first near the 2,000rpm at cold, and goes down when in gear, but mine has never gone higher?
I'll help an eye of your thread just in case something is starting to go in mine
Re: Idle problems
Posted: Fri Feb 28, 2014 3:34 pm
by Daniel2019
Should jump to about 2k on first startup then gradually drop to about 800 when its warm.
Re: Idle problems
Posted: Fri Feb 28, 2014 3:48 pm
by destinationtoby
Mine did the same when I didn't put the tps(I think it's called) hose back on properly
Re: Idle problems
Posted: Fri Feb 28, 2014 4:59 pm
by Daniel2019
Hmm.
I also have a fluctuating idle. Its almost like its misfiring but it isnt as rapid. And is fine under load.
Re: Idle problems
Posted: Fri Feb 28, 2014 5:41 pm
by Bennoz
Daniel2019 wrote:Hmm.
I also have a fluctuating idle. Its almost like its misfiring but it isnt as rapid. And is fine under load.
You should be looking for someone to blame
Re: Idle problems
Posted: Thu May 22, 2014 4:47 am
by payaya
Your stepper for sure.
Re: Idle problems
Posted: Thu May 22, 2014 8:37 pm
by Daniel2019
Wasn't stepper
Re: Idle problems
Posted: Fri May 23, 2014 3:24 am
by payaya
What was it then?
Re: Idle problems
Posted: Fri May 23, 2014 7:48 am
by Daniel2019
Vac hose not connected properly!
