FTO AUSTRALIA

anyone have a pic of these two together or know where i can find one?

keep in mind this was taken with a mobile phone



but these are my dials, dial cups, deep dish rings and stainless gauge surround

That complete set will be very expensive . !~

Beme007 wrote:That complete set will be very expensive . !~

you don't have to buy it all in one go though

A cheaper alternative is to simply spray paint the existing plastic surround.

Doing this in a metallic paint doesn't look as good as the alumium surround, but it is a lot cheaper. Doing it in a non-metallic colour (e.g. white, red etc.) can look really good, but it also depends upon what else you've done ot your interior.

smorison wrote:

Beme007 wrote:That complete set will be very expensive . !~

you don't have to buy it all in one go though

It might be very expensive and you might opt to buy those components one at a time, but I would still recommend installing them all in one go. That way you don't have to pull apart your dash more than once . Buying them together might also save you shipping costs.

Hello,

Does the needle cups come with the ones for the clock and the voltmeter?
Cause I saw one done on some one else's FTO and they only had it for the dash and none for the clock and the voltmeter and it looked bad!

Can they get the whole set?

Or do they come as a set like that but that guy just didn't have it for his FTO?

Thanks,

fto12345 wrote:Does the needle cups come with the ones for the clock and the voltmeter?

Yes,

Have a look in the FTO Shop, it states it comes with 6 cups to cover all the needles:
http://www.ftoaustralia.com/modules.php ... d&prodID=4

ruchi wrote:

fto12345 wrote:Does the needle cups come with the ones for the clock and the voltmeter?

Yes,

Have a look in the FTO Shop, it states it comes with 6 cups to cover all the needles:
http://www.ftoaustralia.com/modules.php ... d&prodID=4

I would kill, to see some dials for the few of us, with vacume and oil temp gauges, instead of the uselsess clock and volt meter!!!

fto12345 wrote:Cause I saw one done on some one else's FTO and they only had it for the dash and none for the clock and the voltmeter and it looked bad!

I'm also one of the guilty party . Got the whole set, but haven't bothered to install the clock and voltmeter rings. It's a little bit more complicated because you actually have to take the clock needles off.

rxboy wrote: I'm also one of the guilty party . Got the whole set, but haven't bothered to install the clock and voltmeter rings. It's a little bit more complicated because you actually have to take the clock needles off.

But unlike the speedo, the clock still work when you put the needles back, i've done it on mine, & had no problem.