FTO AUSTRALIA

Ok as some of you may know I have recently purchased Andrews red rocket I finally got to have a look over it today
And I found a few things it needs

Front wheel arches
Front sway bar drop links
The rear lower camber arm outer bushes hopefully you know which arm I'm talking about
The seal at the rear of the engine for the turbo oil feed

Does anyone know where I can get these things

O btw it's has a 6A13TT with stock turbos

get a tune first

I can get you brand new splash shields (wheel arch liners)

silverGPX wrote:get a tune first

+ fix cold start issue

silverGPX wrote:get a tune first

Can't tell if serious or sarcasm

dstocks wrote:I can get you brand new splash shields (wheel arch liners)

Sweet how much

Will get a quote and get back to you

May be keen for some arches as well at some stage...

Alright. Will post a price in this thread.

Cheers

Did you plug the electronic boost controller back in and up the boost back to 14psi?

Its just got the sh*tty boost tee plugged in and its on minimum.

silverGPX wrote:Did you plug the electronic boost controller back in and up the boost back to 14psi?

Its just got the sh*tty boost tee plugged in and its on minimum.

No not yet I can bearly get thing grip with the stock boost it needs wider tyres before I can really wind it up

dstocks wrote:Will get a quote and get back to you

Thanks Dwayne

Shenal wrote:

silverGPX wrote:Did you plug the electronic boost controller back in and up the boost back to 14psi?

Its just got the sh*tty boost tee plugged in and its on minimum.

No not yet I can bearly get thing grip with the stock boost it needs wider tyres before I can really wind it up

Pfft... soft

What size are you running at the moment?

Daniel2019 wrote:

Shenal wrote:

silverGPX wrote:Did you plug the electronic boost controller back in and up the boost back to 14psi?

Its just got the sh*tty boost tee plugged in and its on minimum.

No not yet I can bearly get thing grip with the stock boost it needs wider tyres before I can really wind it up

Pfft... soft

What size are you running at the moment?

215/35R18 my other 2 are on 225/40R18 I definitely prefer the diameter of my other 2 they fill the wheel arch nicely
but the 215 look small and they sit in to far from the outer edge.
What's the widest tyres someone has got on there car with out cambering the hell out of them or stretching them and
still having them still fit inside the fender.
Actually better question what does bennoz have on to grip with his.

Ben has 18s and spacers to fit his Brembos. Spacers would allow him a bigger tyre too so that comparison would be slightly off me thinks.

235/40/18 on an 18 x 8 rim (+38 offset) with a -20mm spacer on front, -15mm on the rear.

Bennoz wrote:235/40/18 on an 18 x 8 rim (+38 offset) with a -20mm spacer on front, -15mm on the rear.

Sweet thank you what's the FTO stud pattern

Front sway bar drop links
The rear lower camber arm outer bushes hopefully you know which arm I'm talking about
The seal at the rear of the engine for the turbo oil feed

So does anyone know where to get these items

Bennoz I'm not sure how much of my setup is the same as yours but do you know if I can get a new seal for the oil feed
to the rear turbo

Ok don't worry about the drop links I just found out from Andrew this is a auto GR with a 6A13TT and manual conversion
And I know where to get the drop links for a GR