Page 1 of 1
ECU pin outs any difference pre-post facelift?
Posted: Tue Mar 06, 2012 2:54 pm
by Rob Furniss
Got an emanage blue to wire in and i've done one before on a pre-facelit and have pinout diagram but I have a late model 1997 facelift GPX and wondering if there are any differences?
Re: ECU pin outs any difference pre-post facelift?
Posted: Tue Mar 06, 2012 3:28 pm
by Astron_Boy
Good question.
I wouldn't think so.
The engines were all the same, gearbox had it's own ecu.
Only thing I can think of is 'maybe' different wire colors...
Nothing was changed or added over the years with the gr or gpx.
Re: ECU pin outs any difference pre-post facelift?
Posted: Tue Mar 06, 2012 4:11 pm
by Rob Furniss
That's great thanks for confirming, will get cracking and get the emanage installed then.
Re: ECU pin outs any difference pre-post facelift?
Posted: Tue Mar 06, 2012 7:48 pm
by Shane001
Personally I would take the time to verify the wires that you need to cut/connect.
From memory my 95GPX did have a few subtle differences to the ecu pinout & 98 model FTO electrical manual that is available on here and the Internet.