Page 1 of 1
Help fitting Master Battery Switch
Posted: Sun Oct 30, 2011 8:53 pm
by d_dan
I'm fitting a 6 point battery kill swtich.
and 1 of the connection's goes to kill the ignition coils.
But what do i do for the ignition coils as the car has 3 output's A, B, & C. Do I cut them all or just 1 of them?
Re: Help fitting Master Battery Switch
Posted: Sun Oct 30, 2011 11:23 pm
by Shane001
Hold the fort, if you can give me a couple of days I'll dig out the wiring diagram, won't be till mid week though as too busy, so if you can wait...
Re: Help fitting Master Battery Switch
Posted: Mon Oct 31, 2011 4:41 am
by d_dan
No problem. thanks a million
Re: Help fitting Master Battery Switch
Posted: Fri Nov 04, 2011 6:25 am
by d_dan
bump
Re: Help fitting Master Battery Switch
Posted: Fri Nov 04, 2011 9:30 am
by Shane001
haha, sorry mate, just realised I forgot about this, has been a chaotic week.
I'll put them up for you today, just have to dig out my notes.
Cheers.
Re: Help fitting Master Battery Switch
Posted: Fri Nov 04, 2011 9:52 pm
by Shane001
Hi mate, I figured I'd post this as a DIY for everyone to easily find, see link;
viewtopic.php?f=10&t=24663
So essentially you don't touch your ECU wiring, this wires into your ignition switch. Other than rewiring your battery and starter motor to go through this switch, you only actually cut 1 wire, the ignition switch wire number 3. See link for full instructions
Re: Help fitting Master Battery Switch
Posted: Fri Nov 04, 2011 10:05 pm
by d_dan
cheers man