FTO AUSTRALIA

Hi guys,
only realised today that there is a breather pipe going from the manifold to the intake pipe as seen here:

http://ftoaustralia.com/v3/viewtopic.ph ... 22#p248422

Where would I source one of those filters from?

Also, most of the 90 degree pipe seems to short with 2 of them and the MAF sensor. Is there any place where I could source a longer 90 degree 3" pipe from? Supercheap Auto has nothing a long with Autobarn.

Thanks

How about adding a short straight silicone pipe + a short straight aluminum 3" pipe?

And those breathers cost nothing at any autostore... Just get the right size inlet though.. i think it's 10mm or 9mm or something?

or go the next level and add a oil catch can
theres a member on here think hes from the uk but he sells the pipes

bduffman wrote:or go the next level and add a oil catch can

Or go a level between the breather and catch can and make yourself a homemade catch can, like someone on here

Ok thanks, I should be able to custom fit a breather then if that's all it is.

For the 3" pipe, does anyone know a good store to buy it from? As said the current 90 degree bends only look good for the 2 ends and don't look long enough unlike the pipe in that topic I linked above,

cheers

*bump*

Still wondering where I can buy the pipes from. Or does anyone have one from a GR that they want to part with?

Anyone?

eBay is best for any size silicone pipes.

I've checked Ebay, and the ones that are good look too short in length.

The diameter and angle is right, it's just 2 of these + the MAF won't be long enough to reach the front right of the engine bay.

http://www.ebay.com.au/itm/HEAVY-DUTY-S ... 1e5e1fe293

Unless someone can correct me and 2 of these with an MAF and POD filter will reach?

ie: I'm aiming for this setup: