Page 1 of 1
tuning question
Posted: Wed Jun 08, 2011 2:12 pm
by CHR15
hey guys just need some help or guidence i've brought a tuning program called evoscan to read th ecu and diagnostic codes and i've brought the right cable. all this is ment to work in the fto but when i hook it all up and start the logging and reading i'm not getting a response from the ecu. has anyone used this program or mite be able to help me???
Re: tuning question
Posted: Wed Jun 08, 2011 3:20 pm
by Supplanter
Is the engine light in the dash flashing when you plug the cable in?
Re: tuning question
Posted: Wed Jun 08, 2011 5:22 pm
by CHR15
no it doesnt
Re: tuning question
Posted: Wed Jun 08, 2011 7:04 pm
by Storm
Then you still need to ground pin 1 to let it work
You also need to set the baud rate to 15625 to get it to read properly
Re: tuning question
Posted: Wed Jun 08, 2011 8:57 pm
by CHR15
thanks guys for your help. so pretty much i just ground pin 1 and the program should work???