Page 1 of 1
o2 Sensor Grommet
Posted: Wed Nov 17, 2010 7:42 am
by Dras
I have managed to break the little plastic clips that hold the o2 sensor grommet in place. Does anyone have any bright ideas as to how I can fix the grommet in place?
Re: o2 Sensor Grommet
Posted: Wed Nov 17, 2010 9:26 am
by storm hawk
Have the same problem I done think it"s not broke The white plastic clip is still in the floor pan I think the black rubber grommet fit over the lip on plastic piece but wont stay there.I put silicone on it ,held it in place with 2 cut off broom handles.
Just off hand how your front bar .
Re: o2 Sensor Grommet
Posted: Wed Nov 17, 2010 11:14 am
by I8A4RE
Yeah when I did mine I broke the clip as well.I just used a liquid gasket worked a treat and still easier enough to remove if/when I need to.
Re: o2 Sensor Grommet
Posted: Wed Nov 17, 2010 11:45 am
by Dras
I8A4RE wrote:Yeah when I did mine I broke the clip as well.I just used a liquid gasket worked a treat and still easier enough to remove if/when I need to.
Sweet, I was thinking about doing something elaborate with metal clips, didn't even cross my mind to use liquid gasket. Thanks for that.