FTO AUSTRALIA

How do you do it?

thanks in advance

Generally just stick it in & thrust, wbu?

Were not talking bout 13year old virgins here kustom lol

Just to add to this question mine has a leak or some thing where would it leak from

You bleed from the slave cylinder which is located on the gearbox, just behind the radiator hoses.

Has a bleed nipple (yes I said nipple) that you open & bleed with just like you would do the brakes. Ie take lid off master cylinder, fill with fluid, pump pedal & then hold down, release bleed nipple, tighten bleed nipple, release clutch pedal - repeat - adding more fluid to the master cylinder as required.

Its usually the slave that goes, but I you really ought replace both master & slave at the same time. When mine went, I replaced the slave, then 20kms later the master blew

can i use DOT 4 brake fluid in it?

Yep