Page 1 of 1
Good Place in vic to get a piggyback installed and tuned?
Posted: Wed Oct 20, 2010 12:37 pm
by brent88
hey does anyone know a few places in vic i can ring that are good with fto's or mitsubishi's to instal a piggyback ecu? I can buy 1 or buy it through them.
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Thu Oct 21, 2010 3:32 pm
by I8A4RE
Yes
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Thu Oct 21, 2010 3:58 pm
by silverGPX
lol haltech man
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Sun Oct 24, 2010 10:20 am
by brent88
what about just getting my ecu flashed?
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Sun Oct 24, 2010 10:55 am
by silverGPX
cant be done.
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Sun Oct 24, 2010 1:32 pm
by Bennoz
Try
http://www.revzone.com.au/
Some of the older VIC crew used to go there.
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Fri Nov 12, 2010 9:39 pm
by brent88
revzone would charge me 1950 for haltech interceptor fitted dynotuned etc so i dunno if ill go down that route. wonder if i could install 1 myself? could it be harder then a timing belt? some other place quoted me 2,700 but i forget what ecu they said they werre gonna use but he said it was a piggyback
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Fri Nov 12, 2010 9:40 pm
by brent88
obviously i know iu cant tune it btw
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Sat Nov 13, 2010 8:50 am
by Bennoz
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Sat Nov 13, 2010 10:55 am
by silverGPX
if someone replaced the digital ins and outs and analogs whatever for the corresponding fto one id attempt it myself.
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Sat Nov 13, 2010 1:03 pm
by brent88
um anolouge and digital? if i had something that said what wire goes to each sensor, wire etc i could do it but then i would still have to pay to get it tuned and buy the unit
Re: Good Place in vic to get a piggyback installed and tuned
Posted: Sat Nov 13, 2010 1:07 pm
by brent88
yeah i could see myself getting stuck with certain things but i would be able to do it id just asking where to find wires all the time on the forum lol i dont know where the induction control valve position sensor 11,12 and 2 are
