Page 1 of 1
Bonnet release
Posted: Thu Sep 30, 2010 6:56 pm
by Tippin
Tried to do an oil change today and my bonnet wouldn't pop up lol
any other way to release the bonnet?
Re: Bonnet release
Posted: Fri Oct 01, 2010 12:02 am
by bduffman
As far as I no the only way is pulling the cable
Have you tryed taking the pannal under stearing wheel off to make sure its still connected there either that or try locate the cable under the bonnet some how
Good luck
Re: Bonnet release
Posted: Fri Oct 01, 2010 12:09 am
by SchumieFan
if you dont got no mesh you can reach up through the bumper intake and open it...
done it once in a smash
Re: Bonnet release
Posted: Fri Oct 01, 2010 2:12 am
by Shhtuart
Bend the little pipe nozzle the wd 40 cans have in the panel spacing towards the general area of the release latch.
Same thing happened to me but once the wd40 loosened it i chucked some silicon based lubucant all over the latch and it pops up everytime now.