FTO AUSTRALIA

Unichip 'type A' I purchased this from Dstocks approximately 18 months ago, after which it has sat in bubble-wrap in a drawer.

I've read claims that it will provide with a 15Kw increase and will also de-limit the factory speed restriction.

There's plenty of threads out there on this one, so feel free to do your research.

If I remember Dstocks sold it to me for $300. I've always found his pricing exceptionally bargain basement. So at $250 this is huge bang for your buck.

Please PM if interested

I might consider this as my intake/exhaust mods are now complete but i will be getting suggestions and opinions from other members to see if this is good enough compared to maybe a haltech interceptor.

I had one of them on my old GR motor (may well have even been this one lol, its been passed around a like a doobie.)

Got 10 killerwasps from it.

You'll get more from a Haltech Interceptor thou, but you'll pay twice the price.

*Prepares for 11 page, question filled, Goldwayne-esque exhaust thread*

LOL!

i just want something that's not overkill, something that is ideal for my simple setup.
(*hey ben, install my extractors for me for x 6pack(s)? *)

nope your wrong ben,

I had your one which I got from Charlie who got it off someone one which is now owned by Pete??

lol

bushido wrote:nope your wrong ben,

I had your one which I got from Charlie who got it off someone one which is now owned by Pete??

lol

Haha, and it was previously owned by Dimi & before that it was Jeffs! It was in Jeffs GR before it went 6A13 & sold to Mr Charisma

Lol there are three unichips running around the place that have seen more hands than a city hooker on the job

would you guys recommend this chip for my setup? i only have the intake/exhaust mods after all. Or should i go all out haltech interceptor?

I'll give you the pros & cons

Pros:
- its cheap... real cheap
- you'll get your 10kws
- install & tune will only be about $500

Cons:
- there are a limited number of people who have the licence & gear to tune them
- Its an older device, the mapping points are considered 'coarse', aka fewer of them, therefore you won't be able to drag every last inch of power out.

The Haltech will cost you closer to a grand, plus $500 for fit & tune. With that you'll get 15, maybe more killerwasps out of it.

Its up to your wallet really....

well personally, i would just go for the haltech and it might be better overall anyway.

Haha, and it was previously owned by Dimi & before that it was Jeffs! It was in Jeffs GR before it went 6A13 & sold to Mr Charisma

Thanks for the history lesson.

Is (this) a haltech that's good enough for my application?