FS: Tarmac adjustable strut brace
Posted: Fri Jul 16, 2010 11:12 am
Recently upgraded my vehicle, so this is no longer needed!
Its seen some service, in fact its been on my car for the 8 years I've owned it.
The end plates could use a repaint & there are some small machined out sections
on the underside of the bar where I modified it to fit over the 6A13 lump, before
I decided to put some slight bends in the bar itself. The way it currently is, it'll fit
any FTO including those with ABS.
I'll take $50 for it, but if you wanna start a bidding war, knock yourselves out
Will freight at buyers expense
Its seen some service, in fact its been on my car for the 8 years I've owned it.
The end plates could use a repaint & there are some small machined out sections
on the underside of the bar where I modified it to fit over the 6A13 lump, before
I decided to put some slight bends in the bar itself. The way it currently is, it'll fit
any FTO including those with ABS.
I'll take $50 for it, but if you wanna start a bidding war, knock yourselves out
Will freight at buyers expense
