FTO AUSTRALIA

thinking of buying a unregisterd FTO with a veilside bodykit, but its unlicensed because the bodykit is too low?? is there anyway to get it through the pits without taking off the bodykit??

im in perth btw, i think the minimum is 12 cm above the road. not sure though

over sized tyres and wheels?
don't suppose it has adjustable suspension does it?

yeh i was also thinking about over sized tyres and wheels but im not sure if it will be a problem at the pits, dere usually picky with imports. hmmm not sure, i'll ask, if it doesnt, how much do you reckon is it for the suspensions?

Just get a standard bar take it over the pits then swap back as soon as your done.

I8A4RE wrote:Just get a standard bar take it over the pits then swap back as soon as your done.

+1

sorry, im new to this kinda thing. what do you mean by standard bar? like a stock kit or...?

agareenFTO wrote:sorry, im new to this kinda thing. what do you mean by standard bar? like a stock kit or...?

yep stock bar

Yeah just borrow one if you can from another member or buy one. You can get them for $100-$150 then sell it after your finished. It doesnt even need to be perfect

hmm, yeah that sounds like the best thing to do, so would i be needing just the front bar or the whole kit? because the car got a full veilside bodykit

depends on how low the rest of kit is? can you get some pics up? How low is the car.

In qld and I think nsw, the car cant be any lower than 100mm