Page 1 of 1
tappet part ????gpx mivic
Posted: Mon May 10, 2010 5:13 pm
by andy123
on my left bank head the tappet clearnce it near 50 mm
is their something that fill up that space ?
the head was removed from that last owner and im still very noob
Re: tappet part ????gpx mivic
Posted: Mon May 10, 2010 5:23 pm
by JOeJOe
take it to a mechanic that know'w what they're doing and get them to adjust the tappets
Re: tappet part ????gpx mivic
Posted: Mon May 10, 2010 5:53 pm
by andy123
when i take out the cam i notice a few metal thing fall out im guessing it seat on the valve or the tappet screw ????????
something is missing ?????? is it broken part ?
Re: tappet part ????gpx mivic
Posted: Mon May 10, 2010 5:54 pm
by andy123
5 cm it a very big gaps
Re: tappet part ????gpx mivic
Posted: Mon May 10, 2010 6:06 pm
by andy123
this is the 2 part that i found on the head
can some one tell me what it is and where it located
Re: tappet part ????gpx mivic
Posted: Mon May 10, 2010 8:12 pm
by vipfto
its the little colets for tappets they sit over them.
I would not be removing heads if you dont know what your doing mate? and that will bereason for gap in clearence as they prob wont be seated in there
Re: tappet part ????gpx mivic
Posted: Mon May 10, 2010 8:43 pm
by andy123
how do they sit on ? the round 1 or the curve one
where can i buy this part
Re: tappet part ????gpx mivic
Posted: Tue May 11, 2010 10:57 pm
by andy123
what could happen if i dont put this part back ?