FTO AUSTRALIA

Not really a problem, but more of a general question..

The set of kick panels I got have plug still attached to them, instead of having to splice the wires.. So without pulling the car apart as yet... Does anyone know where the plug should go..???

Kick panels plug into fuse board on driver's side under dash

Sweet.. So I guess there will be something their labeled for the door light.. Or is their only 1 plug that it will fit into...

Hmm I'd have to go have a look. I'm quite sure they aren't labeled, but yea I think that there is only one plug they can fit into...

*Goes outside to take photo*

Edit: Ok, so a combination of darkness, mild drunkness and the fact that my car is parked on the side of the road restricted me from being able to get a good look...

I'll try again tomorrow...

Thanks for going to so much trouble mate.. Really appreciated...

if you don't have the electrical board that the kick panels plug into then you just have to wire them into the door lights..

I wired mine into the interior lights. Just removed the pilar cover and joined it in there. I think its a green wire with a black stripe from memory

mr-charisma wrote:if you don't have the electrical board that the kick panels plug into then you just have to wire them into the door lights..

I have the electrical board .. With a fuse I think.. So yeah it has the plug to go somewhere, that I haven't looked for as yet...

Yesterday was cleaning all the glue and double sided tape..

I may hook some neon's up to the kick panels as well..

mr-charisma wrote:if you don't have the electrical board that the kick panels plug into then you just have to wire them into the door lights..

This ^

just wire into where switch is

Problem with the door switch is its earth based from memory (no live wire). Easier to wire into the interior lights in the rear vision mirror.