Page 1 of 1
FS: RPW extractors to suit 6A12 non mivec
Posted: Thu Dec 11, 2008 1:15 pm
by Bennoz
As above, got a set of extractors to suit a GR. They came off my old motor. Have a few minor dings on the bottom of the collector pipe from bottom outs, but are fine otherwise.
$350
Will post at buyers expense.
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Fri Mar 28, 2014 11:25 am
by bumpak
Hey mate do you know if these will fit a mivec 6a12?
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Fri Mar 28, 2014 11:30 am
by Bennoz
Dude... this thread is 6 years old lol. Extractors are loooong gone.
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Fri Mar 28, 2014 12:27 pm
by kiz
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Fri Mar 28, 2014 12:28 pm
by kiz
Bennoz wrote:Extractors are loooong gone.
Probably been passed through many hands now like the town slut
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Fri Mar 28, 2014 4:03 pm
by Technikhaus
Bahaha!
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Sun Mar 30, 2014 10:03 pm
by bumpak
So does anyone know if the 6a12 non mivec and mivec use the same headers?
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Sun Mar 30, 2014 10:04 pm
by Sahin
Pretty sure they dont
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Mon Mar 31, 2014 7:26 am
by Bennoz
They're exactly the same. Only difference is where the collector pipe mates up with the the flange on the cat. It's slightly different on the GR, yet easily resolvable with a drill.
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Mon Mar 31, 2014 2:06 pm
by Sahin
It's actually way off on the cat lol
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Mon Mar 31, 2014 2:13 pm
by Bennoz
You need a bigger drill.
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Mon Mar 31, 2014 2:14 pm
by Sahin
It wasn't even the same diameter pipe when I tried lol had to get another y pipe made up
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Mon Mar 31, 2014 2:25 pm
by Vectose
Wasn't that far off when fitting FTOwnage's. Used a slightly smaller diameter bolt.
Mine had stock exhaust but aftermarket cat and bolted up perfectly.
Re: FS: RPW extractors to suit 6A12 non mivec
Posted: Mon Mar 31, 2014 2:27 pm
by Sahin
Mehhhhhhhhhhhhh lol
