FTO AUSTRALIA

Hi
I know I am stupid. Please teach me how to ground out the earth for the ECU connector?

According to the insruction how to get ECU code.. http://www.ftowa.com/html/workshop/workshopart07.html

Err exactly what it says. Earth that pin? Wire from that pin to a chassis earth somewhere.

could not put the cable stable with the connector..

seems it is a 2 men job....

I'm sure there's a way to do it alone.

Would you please teach me how to do it alone please....

Dr Jone

You probably already know this, but, to ground out the pin, you plug in a wire into the pin & connect the other end to any bare metal part of the chassis..

You can do it without 2 people.. plug one end of the wire into the pin, & hook the other end over any piece of bare metal .. you don't need to hold it there..

solder one end up to an alligator clip if it helps

yeah I was going to suggest an alligator clip too.

Dr_Jones wrote:yeah I was going to suggest an alligator clip too.

Or maybe just the aligator

Finally come up with one man's job because there is a small hole I can stable the wire..

The Engine light keep blinking.

But the Neutral transmission light have 2 long shot and 2 short shot..

Check with the workshop manual, does not come up with anything.

Anyone come up with this before?

Thanks in advance

poposay wrote:Finally come up with one man's job because there is a small hole I can stable the wire..

The Engine light keep blinking.

But the Neutral transmission light have 2 long shot and 2 short shot..

Check with the workshop manual, does not come up with anything.

Anyone come up with this before?

Thanks in advance

2 long, 2 short sounds like "22" to me
Fault 22: Crank angle sensor

Supplanter wrote:

poposay wrote:Finally come up with one man's job because there is a small hole I can stable the wire..

The Engine light keep blinking.

But the Neutral transmission light have 2 long shot and 2 short shot..

Check with the workshop manual, does not come up with anything.

Anyone come up with this before?

Thanks in advance

2 long, 2 short sounds like "22" to me
Fault 22: Crank angle sensor

If it were the engine light making the 22 signal it would be, but its the tip light thats doing it. Will have to look up what 22 is for the tip box....I'd go onto the pommy site, but my account has expired.

No offence but if you done know how to ground a wire wouldnt it be pointless diagnosing a problem as it would be way more difficult to fix????????

I was not use the correct cable first time. That is why It was not able to put the wire in..

I found a tv cable, then it is quite easy