Page 1 of 1
PLaaaaaaaaasSStic Help!
Posted: Tue Dec 04, 2007 9:39 pm
by dj_ules
hey i wanna repair my bump bump bar.
got some fiberglass, and its very tasty glue friend . will this stick to the plastic standard fto bumper bar !! just clean the surface and away i go
or is there any other process i should do.. or should i not attempt to use fiberglass on plastic !!
shanks for your time !!
Posted: Tue Dec 04, 2007 10:11 pm
by Bennoz
Are you drunk Jules
Posted: Tue Dec 04, 2007 11:32 pm
by BorepYano
Bennoz wrote:Are you drunk Jules
lol
and as far as i'm aware, fibreglass doesnt really stick to plastic too well (definately not baby bottom smooth polished plastic), but... u can probably get away with sanding the crap out of the area u want to fibreglass with 45 grit sand paper.
a better way (depends on the dmg) is... if it's just a crack - q-bond it (i think it's called q-bond, it's pretty much super super super glue that sticks anything to anything... perminately), then bog in the gaps. and of course sand it smooth. but if it is a pretty bad crack then u'll probably have to fibreglass it
and definately dont so this when drunk!!
Posted: Wed Dec 05, 2007 10:26 am
by dj_ules
haha i wish i was drunk nah..
its not a crack.
its where i have cut out the middle part of the standard bumper..
so i can make that nice new gaping hole look.
on the sizeds i wanna whack fiberglass and then bog, to make that new look. like the guys from the uk wher doin it,
i went and saw a few guys and cheapest was quoted like 170$ just to plastic weld 2 little pieces on . bit of a raught i rekon .!