FTO AUSTRALIA

Hey guys , i just wanna get a dyno sheet for my fto before i put some mods on,,can anyone tell me where is the better place to go?how much it would cost me ? i am in Marsfield ,Sydney area, any suggestions?
who has the most power NA fto here ? what's the figure?
thank u guys..

We had a group Dyno day at Menai a little while back ... Pulse racing I think it was ...

As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...

I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...

As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...

What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...

I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...

Here you go ...



and thread is here ....

http://www.ftoaustralia.com/modules.php ... &start=100

Most powerful n/a fto dyno i've heard in Aus is 126kw atw. I believe Bennoz's once achieved this ? But now runs at around 120kw atw. Boris's car had 126kw atw too.

You should ask Spetz for a dyno sheet if he's willing to give it out. Safe to say he owns one of the most worked (bolt on wise) fto engines in Aus.

Stock manual should get anywhere from 90-95kw atw.

I got to 115.6kw atw myself but the project was never finished.

rock_it wrote: BD4's had a Dyno at Ryde

BD4's is gone...has been for awhile. They also had an old mainline dyno one eww (and it also read high).

Btw, price wise you're looking at between $60-$88 for 3 or 4 runs (depends on the place).

Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now Its a nice car hehe

robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now Its a nice car hehe

Did you get the rpw pipes off him as well? It'd go like the clappers with them on

robsta,

Definitely a nice car...if i didn't have mine i would've bought that one too. And it eventually went for way under what it should've...nice pick!

rock_it wrote:We had a group Dyno day at Menai a little while back ... Pulse racing I think it was ...

As I am from the South ... I go to Ricol @ Peakhurst ... They have built/service all my cars ...

I am not too sure of who has Dyno's in your area ... I use to Live at Putney, and I know that BD4's had a Dyno at Ryde, and I think MRT may also have one ... Think they are now at Rhodes ... As for that, any performance shop in the area should be able to assist...

As for cost ... Well do the ring around.... If it is a dyno + Tune it will cost more... If it is just a Dyno run, then it should not be too much ... I know that Ricol do 3 runs on the Dyno (on club Dyno days) for about $50 ... Pulse did ours for about half that ... But we had a fair few people ...

What is the most power for a N/A FTO .... Well not too sure on that one ... Have seen about 115kw @ wheels I think ... Depending on if the car is tip or man also .. Tips I think are usually in the 90's, and man's are in the 100 mark ... Also depends on the version too ...

I think there was a picture taken of the results board from the dyno day ... Check in the NSW events section ... I may try and find it also ...

thanks a lot ,ROCK_IT !! i think MRT is the closet place but they charge $150 for 3 dyno runs...i think its too expensive ...
my fto is YELLOW GPX MANUAL 95MODEL , LIMITED EDITION..only done the exhaust and intake system..67000KMS ...excellent condition...i hope my fto can get around 105kws atw..i will post some pics later on..
I will probably go for Richol.. anyone got address?

Lol $150 for 3 runs...hahaha.

Bennoz wrote:

robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now Its a nice car hehe

Did you get the rpw pipes off him as well? It'd go like the clappers with them on

Nah It didn't come with the RPW pipes, he must of sold them already cause he didnt mention them.
Although they will be turning up at my work in a couple of days I ordered some myself haha

robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now Its a nice car hehe

Oh so you the one who got Borris's ride, lucky you, he love his FTO like a baby.

Yeah I've got the dyno graph of Boris, Grant and Pete's FTO (all ACT members), from memory Grant got the highest output of the three.

robsta wrote:Correct Borris did get 126kw in his FTO, which I own now, I'm hoping to get another Run soon to see how its going now Its a nice car hehe

126KWS atw ?!!! this is awesome... what mods have u done on your fto? can u list them?any pics?what model is it?

hey yellowftogpx, got a pic of your car? i'm yellow too!

akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!

yeh, i want to ..but how ?? have no idea how to post the pics.
[/img]

yellowftogpx wrote:

akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!

yeh, i want to ..but how ?? have no idea how to post the pics.
[/img]

get photobucket.
and if u don't know what that is, google it

akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!

Better yet, make a gallery on the ... gallery.
http://www.ftoaustralia.com/modules.php?name=gallery2

eThix wrote:

yellowftogpx wrote:

akumi wrote:hey yellowftogpx, got a pic of your car? i'm yellow too!

yeh, i want to ..but how ?? have no idea how to post the pics.
[/img]

get photobucket.
and if u don't know what that is, google it

THANX MATE !
HERE IS THE LINK http://s239.photobucket.com/albums/ff68/clydesfto/
they were taken in the garage so they look a little bit dark ..
i will take more pics under the sunshine another day..

I had clutch die at 188hp... at 3,500rpm... and it was rising quickly...


aiming for 300hp when its back in a few weeks... but have been warned it may creep over the 500hp mark with it setup for power...



but its not N/a...


Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...

would be over 160kw though

FtoSam wrote:I had clutch die at 188hp... at 3,500rpm... and it was rising quickly...


aiming for 300hp when its back in a few weeks... but have been warned it may creep over the 500hp mark with it setup for power...



but its not N/a...


Most powerful N/A engine would be the Freak built by RPW.... hasnt been put in a FTO yet as i dont think anyone has enough balls or cash to get it...

would be over 160kw though

hey sam ,,how much have u spent on your FTO ? how many kws atw your fto got? really want to take a ride in your fto and see how a turbo fto performs..