Page 1 of 1
Need a DIY on replacing the rocket cover seals
Posted: Fri Jun 15, 2007 1:20 pm
by jakey106
Does any one know of a DIY guide to replacing the rocket cover seals?
Posted: Fri Jun 15, 2007 1:55 pm
by Bennoz
Not seen one...spose I could wip one up, I gotta do AJ's car soon.
The dissasembly to get at them is the same as doing tappets... so you could work from that DIY if you wanted.
Posted: Fri Jun 15, 2007 2:06 pm
by JOeJOe
Any part numbers?
Posted: Fri Jun 15, 2007 2:13 pm
by Delvance
For the rocker cover gasket Joejoe ? It's MD309002. The front and rear bank seal is the same, and this is for a mivec. Not sure if non mivec engine is the same.
Got a spare one lying around doing nothing lol.
Posted: Fri Jun 15, 2007 4:10 pm
by JOeJOe
How much are they?
Posted: Fri Jun 15, 2007 4:23 pm
by Delvance
About $66 per. Cheaper if you get the trade discount. You can have mine for $45 if you need one, i've no use for it.
Posted: Fri Jun 15, 2007 8:17 pm
by jakey106
mkay mighht have to go blind is it very hard do u know?
Mine cost me 136 for the pair and that was through mitshubishi