FTO AUSTRALIA

So, one thing follows another, and the alternator is one the way out as well. Found this on ebay, not sure if it's the right one?

http://www.ebay.co.uk/itm/NEW-MITSUBISH ... 6#shpCntId

Says 4 pin, so should be OK.

dstocks wrote:Says 4 pin, so should be OK.

Yeah, and the part number they have listed is MD317515. I saw in one thread that there is apparently a newer version of it, but it's been doing with the older one anyway and this is a lot cheaper than most others.

Dammit, neglected to note that free postage was only for the UK, haha. Still might end up being worth a shot though.

Have had a few occasions of hitting bumps and the handbrake light coming on and not going off for a bit. Thoughts?

bjk wrote:Have had a few occasions of hitting bumps and the handbrake light coming on and not going off for a bit. Thoughts?

I drove a 2011 Triton a few weeks ago that did the same thing.

Vectose wrote:

bjk wrote:Have had a few occasions of hitting bumps and the handbrake light coming on and not going off for a bit. Thoughts?

I drove a 2011 Triton a few weeks ago that did the same thing.

Yeah, I suppose "Thoughts?" was a little too opened ended.

Brake fluid low!

Sahin wrote:Brake fluid low!

Huh. I couldn't get the lid off (is it pressurised or am I just weak?). And I can't tell if the dark bit near the full line is just part of the cap or not. But it doesn't look like any liquid is in there.

You're weak and yep it's gonna be that I'm sure of it

Cool beans. Maybe I'll dash down to Repco and grab me some fluid and a tool kit, lol. I just get the lid off and fill it up, yes?

Just use an oil filter wrench or get ruby to take it off for ya hahahaha

Sahin wrote:Just use an oil filter wrench or get ruby to take it off for ya hahahaha

I have neither of those things!

Tiiiiiim, get back from Japaaaaaan!

Try again wuss

Sahin wrote:Try again wuss

Repco was closed. wasn't even 5pm lol. Might have to do it tomorrow.

Yip brake fluid and toughen up easy to remove. Shouldn't be low though unless have slight leak. Check all bled nipples on calipers too

And master cylinder! Check for leaks

vipfto wrote:Yip brake fluid and toughen up easy to remove. Shouldn't be low though unless have slight leak. Check all bled nipples on calipers too

Yea about to say, must have a leak because I haven't had to fill mine up since we all did our rotors at the same time??

Hmm. Most curious. Kiz and Phil can look for me this afternoon?

bjk wrote:Hmm. Most curious. Kiz and Phil can look for me this afternoon?

Just seen this post and I guess we didn't look at it for ya